Worked example
Example: 300 A / 60 % run at 250 A. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Rated current | 300.00 A |
| Rated duty cycle | 60.000 % |
| Required current | 250.00 A |
Applying the formula below gives:
| Result | Value |
|---|---|
| Allowable duty cycle at I₂ | 86.400 % |
| Current at 100 % duty | 232.38 A |
| Arc-on minutes in a 10-minute cycle | 8.6400 min |
Open this example in the calculator and change any input.
Formula
\(D_2 = D_1\left(\frac{I_1}{I_2}\right)^2, \quad I_{100} = I_1\sqrt{D_1}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(I_1\) | Rated current | A |
| \(D_1\) | Rated duty cycle | - |
| \(I_2\) | Required current | A |
| \(D_2\) | Allowable duty cycle at I₂ | - |
| \(I_{100}\) | Current at 100 % duty | A |
| \(t_{on}\) | Arc-on minutes in a 10-minute cycle | s |
Method and standards
I²t heating.
Where it is used
- Choosing a welding set.
- Planning continuous welding (SAW, cladding).
Common mistakes
- Ignoring ambient temperature derating.
- Running above maximum current.
Assumptions and limits
- 10-minute cycle; thermal equilibrium.
- Currents above the rated current are extrapolated by the I² rule, which makers do not support; never exceed the machine's maximum current.
References
- Equal heating: I₁²D₁ = I₂²D₂ (IEC 60974-1 rating principle, 10-minute cycle)
Questions and answers
What does 60 % duty at 300 A mean?
The machine can weld at 300 A for 6 minutes in every 10 without overheating.
Can I weld longer at lower current?
Yes: duty rises with the square of the current ratio, up to 100 %.
What do the defaults represent?
A 300 A / 60 % machine run at 250 A.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.