FireCADCalc

Transverse Shrinkage of a Butt Weld

Estimated transverse shrinkage of a butt weld from the weld cross-sectional area, plate thickness and root opening, and the total for several welds across a member.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationRefinery and petrochemicalChemical and fertiliserPulp and paper

Inputs

Examples: Single-V 120 mm² in 12 mm, 2 mm gapDouble-V 400 mm² in 30 mm, three seams

Results

Empirical estimate for steel butt welds; restraint reduces shrinkage and raises residual stress. Allow for shrinkage in fit-up (presetting or extra length).

Shrinkage per weld2.1000mm
Total shrinkage2.1000mm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Single-V 120 mm² in 12 mm, 2 mm gap. The inputs, in the units selected above:

InputValue
Weld cross-sectional area120.00 mm²
Plate thickness12.000 mm
Root opening2.0000 mm
Number of similar welds in line1.0000 -

Applying the formula below gives:

ResultValue
Shrinkage per weld2.1000 mm
Total shrinkage2.1000 mm

Open this example in the calculator and change any input.

Formula

\(S = 0.2\frac{A_w}{t} + 0.05d\)

Variables

Symbol Meaning SI unit
\(A_w\) Weld cross-sectional area m²
\(t\) Plate thickness m
\(d\) Root opening m
\(n\) Number of similar welds in line -
\(S\) Shrinkage per weld m
\(S_{tot}\) Total shrinkage m

Method and standards

Blodgett's empirical relation.

Where it is used

  • Allowing for shrinkage in fabrication drawings.
  • Comparing joint designs.

Common mistakes

  • Over-welding (adds area and shrinkage).
  • Ignoring cumulative shrinkage of several welds.

Assumptions and limits

  • Steel butt welds.

References

  • Transverse shrinkage S = 0.2A_w/t + 0.05d (Blodgett, Design of Welded Structures, James F. Lincoln Arc Welding Foundation, 1966, sec. 7.7)

Questions and answers

Why does a weld shrink?

Hot weld metal and the adjacent plate contract on cooling; the cold plate around resists, leaving shrinkage and residual stress.

How do I reduce shrinkage?

Smaller weld area (narrower bevels, less over-weld), fewer passes, balanced welding.

What do the defaults represent?

A single-V butt weld of about 120 mm² in 12 mm plate with a 2 mm root gap.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.