FireCADCalc

Welding Cost per Metre (Labour, Consumables, Power, Gas)

Cost of welding per metre from weld metal per metre, deposition rate, operating factor, labour rate, consumable price, gas and power.

Thermal power plantProcess steam and utilities

Inputs

Examples: Manual stick, 8 mm filletMIG with gas

Results

Labour usually dominates manual welding; raising the operating factor or deposition rate saves the most.

Arc time per metre4.9714min
Labour per metre110.48
Consumables per metre56.739
Gas and power per metre10.937
Total per metre178.15

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Manual stick, 8 mm fillet. The inputs, in the units selected above:

InputValue
Weld metal per metre0.29000 kg/m
Deposition rate1.8000 kg/h
Operating factor (arc time / paid time)30.000 %
Labour and overhead per hour600.00 -
Deposition efficiency60.000 %
Consumable price per kg250.00 -
Shielding gas cost per arc hour0 -
Power drawn while welding6.0000 kW
Electricity price per kWh8.0000 -

Applying the formula below gives:

ResultValue
Arc time per metre9.6667 min
Labour per metre322.22
Consumables per metre120.83
Gas and power per metre7.7333
Total per metre450.79

Open this example in the calculator and change any input.

Formula

\(t_a = \frac{m'}{\dot m_d}, \quad C = \frac{t_a}{f_o}c_L + \frac{m'}{\eta_d}c_e + t_a(c_g + P c_p)\)

Variables

Symbol Meaning SI unit
\(m'\) Weld metal per metre kg/m
\(\dot m_d\) Deposition rate kg/s
\(f_o\) Operating factor (arc time / paid time) -
\(c_L\) Labour and overhead per hour -
\(\eta_d\) Deposition efficiency -
\(c_e\) Consumable price per kg -
\(c_g\) Shielding gas cost per arc hour -
\(P\) Power drawn while welding W
\(c_p\) Electricity price per kWh -
\(t_a\) Arc time per metre s
\(C_L\) Labour per metre -
\(C_e\) Consumables per metre -
\(C_o\) Gas and power per metre -
\(C\) Total per metre -

Method and standards

Cost model.

Where it is used

  • Fabrication quotes.
  • Process comparisons.

Common mistakes

  • Arc time as paid time.
  • Ignoring stub and spatter loss.

Assumptions and limits

  • Average shop conditions.

References

  • Weld cost model: arc time = deposit/deposition rate; labour = arc time/operating factor × rate (AWS and TWI cost approach)

Questions and answers

0.29 kg/m at 1.8 kg/h, 30 % operating factor?

Arc time 9.7 min per metre; labour 322 of the 451 per metre.

How to cut cost?

Smaller welds (less over-welding), higher deposition processes and a better operating factor.

Rates?

Your shop's labour, overhead and prices.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.