FireCADCalc

Single-V Butt Weld Metal Volume and Mass

Weld metal cross-section and mass of a single-V butt weld from plate thickness, included angle, root gap, root face and reinforcement, with consumables.

Thermal power plantProcess steam and utilities

Inputs

Examples: 12 mm plate, 60°25 mm plate, 45°, no root face

Results

Weld cross-section96.418mm²
Weld metal deposited15.138kg
Consumables needed25.229kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 12 mm plate, 60°. The inputs, in the units selected above:

InputValue
Plate thickness12.000 mm
Included groove angle60.000 °
Root gap2.0000 mm
Root face1.5000 mm
Reinforcement allowance (share of the groove)10.000 %
Weld length20.000 m
Weld metal density7,850.0 kg/m³
Deposition efficiency60.000 %

Applying the formula below gives:

ResultValue
Weld cross-section96.418 mm²
Weld metal deposited15.138 kg
Consumables needed25.229 kg

Open this example in the calculator and change any input.

Formula

\(A = \left[g t + (t - f)^2\tan\frac{\alpha}{2}\right](1 + k_r)\)

Variables

Symbol Meaning SI unit
\(t\) Plate thickness m
\(\alpha\) Included groove angle rad
\(g\) Root gap m
\(f\) Root face m
\(k_r\) Reinforcement allowance (share of the groove) -
\(L\) Weld length m
\(\rho\) Weld metal density kg/m³
\(\eta_d\) Deposition efficiency -
\(A\) Weld cross-section m²
\(m_w\) Weld metal deposited kg
\(m_c\) Consumables needed kg

Method and standards

Geometry.

Where it is used

  • Fabrication and pipe welding estimates.
  • Comparing joint preparations.

Common mistakes

  • Half angle vs included angle.
  • Ignoring the root gap.

Assumptions and limits

  • Single-V, no backing.

References

  • Groove geometry: root gap rectangle plus the two bevel triangles
  • (t − f)² tan(α/2)

Questions and answers

12 mm plate, 60°, 2 mm gap, 1.5 mm face?

About 96 mm²: 15.1 kg over 20 m.

Narrower angle?

Saves metal but needs access for the torch and fusion of the side walls.

Double-V?

For thick plate a double-V roughly halves the weld metal.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.