FireCADCalc

Regular Polygon: Area, Across Flats and Across Corners

Area, perimeter, inradius and circumradius of a regular polygon from the number of sides and side length, with across-flats and across-corners sizes (hexagons).

Inputs

Examples: Hexagon 11.5 mm sidesOctagon 1 m sidesTriangle 2 m sides

Results

Area1,732,051mm²
Perimeter6,000.0mm
Across flats (2 × inradius)1,154.7mm
Across corners (2 × circumradius)2,309.4mm
Interior angle60.000°

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Hexagon 11.5 mm sides. The inputs, in the units selected above:

InputValue
Number of sides6.0000 -
Side length11.500 mm

Applying the formula below gives:

ResultValue
Area343.60 mm²
Perimeter69.000 mm
Across flats (2 × inradius)19.919 mm
Across corners (2 × circumradius)23.000 mm
Interior angle120.00 °

Open this example in the calculator and change any input.

Formula

\(r_i = \frac{s}{2\tan(\pi/n)}, \quad r_c = \frac{s}{2\sin(\pi/n)}, \quad A = \frac{n s r_i}{2}\)

Variables

Symbol Meaning SI unit
\(n\) Number of sides -
\(s\) Side length m
\(A\) Area m²
\(P\) Perimeter m
\(AF\) Across flats (2 × inradius) m
\(AC\) Across corners (2 × circumradius) m
\(\alpha\) Interior angle rad

Method and standards

Geometry.

Where it is used

  • Nut and bolt-head sizes.
  • Hex bar and section areas.

Common mistakes

  • Mixing across flats and corners.
  • Angle in degrees.

Assumptions and limits

  • Regular polygon.

References

  • Regular polygon geometry

Questions and answers

Hexagon of 11.5 mm sides?

Across flats 19.92 mm, across corners 23.0 mm.

Spanner size?

Equals the across-flats dimension.

Many sides?

The polygon approaches a circle.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.