FireCADCalc

Staircase Risers, Treads and Going

Number of risers, riser height, tread (going) and the total going of a straight staircase from floor-to-floor height and a target riser, with the 2R + T check.

Inputs

Examples: 3.2 m floor3.0 m floor, 150 mm risersPlant access 4.5 m

Results

Building codes set limits on riser, going and pitch; check yours. A common comfort rule is 2R + T of about 550 to 700 mm.

Number of risers (rounded)20.000
Actual riser height150.00mm
Total going (n − 1) T5.7000m
Comfort rule 2R + T600.00mm
Pitch of the stair26.565°

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 3.2 m floor. The inputs, in the units selected above:

InputValue
Floor-to-floor height3.2000 m
Target riser height165.00 mm
Tread (going) per step270.00 mm

Applying the formula below gives:

ResultValue
Number of risers (rounded)19.000
Actual riser height168.42 mm
Total going (n − 1) T4.8600 m
Comfort rule 2R + T606.84 mm
Pitch of the stair31.955 °

Open this example in the calculator and change any input.

Formula

\(n = \text{round}\left(\frac{H}{R_t}\right), \quad R = \frac{H}{n}, \quad G = (n - 1)T, \quad \tan\theta = \frac{R}{T}\)

Variables

Symbol Meaning SI unit
\(H\) Floor-to-floor height m
\(R_t\) Target riser height m
\(T\) Tread (going) per step m
\(n\) Number of risers (rounded) -
\(R\) Actual riser height m
\(G\) Total going (n − 1) T m
\(2R + T\) Comfort rule 2R + T m
\(\theta\) Pitch of the stair rad

Method and standards

Geometry.

Where it is used

  • Stair layout.
  • Checking drawings.

Common mistakes

  • Equal number of risers and treads.
  • Ignoring the landing.

Assumptions and limits

  • Straight flight.
  • The number of risers is the nearest whole number, so the actual riser can be a little above the target; the page warns then, and when 2R + T is outside 550–700 mm.

References

  • Blondel's rule 2R + T (comfort check)

Questions and answers

3.2 m floor height with about 165 mm risers?

19 risers of 168.4 mm; with 270 mm treads the going is 4.86 m.

Why n − 1 treads?

The top riser lands on the floor above.

What is 2R + T?

Blondel's comfort rule, about one stride.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.