FireCADCalc

Roof Pitch, Rafter Length and Roof Area

Roof pitch in degrees and as rise per run, rafter length including overhang, and the sloping roof area of a duo-pitch (gable) roof from span, rise and length.

Inputs

Examples: 10 m span, 2 m riseShed 24 m span, 1:10Steep 6 m span

Results

Pitch21.801°
Rise per run40.000%
Rafter length including overhang5.9237m
Roof area (both slopes)236.95m²

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 10 m span, 2 m rise. The inputs, in the units selected above:

InputValue
Span between wall plates10.000 m
Rise to the ridge2.0000 m
Eaves overhang (horizontal)0.50000 m
Length of the building along the ridge20.000 m

Applying the formula below gives:

ResultValue
Pitch21.801 °
Rise per run40.000 %
Rafter length including overhang5.9237 m
Roof area (both slopes)236.95 m²

Open this example in the calculator and change any input.

Formula

\(\theta = \arctan\frac{R}{S/2}, \quad L_r = \sqrt{(S/2)^2 + R^2} + \frac{o}{\cos\theta}, \quad A = 2 L_r L\)

Variables

Symbol Meaning SI unit
\(S\) Span between wall plates m
\(R\) Rise to the ridge m
\(o\) Eaves overhang (horizontal) m
\(L\) Length of the building along the ridge m
\(\theta\) Pitch rad
\(R/(S/2)\) Rise per run -
\(L_r\) Rafter length including overhang m
\(A\) Roof area (both slopes) m²

Method and standards

Right triangles.

Where it is used

  • Roof sheeting and truss estimates.
  • Rainwater design areas.

Common mistakes

  • Plan area instead of slope area.
  • Forgetting overhangs.

Assumptions and limits

  • Symmetric duo-pitch roof.

References

  • Right-triangle roof geometry

Questions and answers

10 m span, 2 m rise, 0.5 m overhang, 20 m long?

Pitch 21.8°, rafter 5.92 m, roof area 237 m².

Does the overhang count along the slope?

Yes; it is horizontal, so divide by cos θ.

Sheeting overlaps?

Add the maker's overlap allowance to the area.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.