Worked example
Example: Falling head on silt. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Test | Falling head |
| Sample length | 120.00 mm |
| Sample cross-section | 78.500 cm² |
| Volume collected (constant head) | 500.00 mL |
| Head difference (constant head) | 0.50000 m |
| Standpipe area (falling head) | 0.78500 cm² |
| Initial head | 1.0000 m |
| Final head | 0.50000 m |
| Time | 600.00 s |
Applying the formula below gives:
| Result | Value |
|---|---|
| Coefficient of permeability | 1.3863e-06 m/s |
Open this example in the calculator and change any input.
Formula
\(k = \frac{Q L}{A h t} \quad \text{or} \quad k = \frac{a L}{A t}\ln\frac{h_1}{h_2}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{test}\) | Test | - |
| \(L\) | Sample length | m |
| \(A\) | Sample cross-section | m² |
| \(Q\) | Volume collected (constant head) | m³ |
| \(h\) | Head difference (constant head) | m |
| \(a\) | Standpipe area (falling head) | m² |
| \(h_1\) | Initial head | m |
| \(h_2\) | Final head | m |
| \(t\) | Time | s |
| \(k\) | Coefficient of permeability | m/s |
Method and standards
Darcy's law.
Where it is used
- Soil investigation.
- Seepage and dewatering design.
Common mistakes
- log₁₀ instead of ln.
- Areas mixed up.
Assumptions and limits
- Saturated laminar flow.
References
- Darcy's law: constant-head k = QL/(Aht); falling-head k = (aL/At) ln(h₁/h₂) (ASTM D2434; IS 2720 Part 17)
Questions and answers
Falling head, 120 mm sample, 1 m → 0.5 m in 10 min, area ratio 1:100?
k = 1.39e-06 m/s, a silt.
Which test for clay?
Falling head, or the oedometer.
Temperature?
Correct to 20 °C with the viscosity ratio if needed.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.