FireCADCalc

Four-Stroke Engine Volumetric Efficiency

Volumetric efficiency of a four-stroke engine from measured air flow, air density, bore, stroke, cylinders and speed.

Inputs

Examples: Turbocharged sixNaturally aspirated four

Results

Above 100 %: with ambient density this means boost (turbo- or supercharging); with manifold density a boosted engine normally reads below 100 %, so recheck the density basis.

Four-stroke only: one intake stroke every two revolutions. A two-stroke engine draws once per revolution, so its swept volume rate is V_s N.

Swept volume rate V_s N/2280.55m³/h
Volumetric efficiency195.74%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Turbocharged six. The inputs, in the units selected above:

InputValue
Measured air flow648.00 kg/h
Intake air density (ambient or manifold)1.1800 kg/m³
Bore105.00 mm
Stroke120.00 mm
Cylinders6.0000 -
Speed1,500.0 rpm

Applying the formula below gives:

ResultValue
Swept volume rate V_s N/2280.55 m³/h
Volumetric efficiency195.74 %

Open this example in the calculator and change any input.

Formula

\(\eta_v = \frac{\dot m_a}{\rho_a V_s N/2}\)

Variables

Symbol Meaning SI unit
\(\dot m_a\) Measured air flow kg/s
\(\rho_a\) Intake air density (ambient or manifold) kg/m³
\(B\) Bore m
\(S\) Stroke m
\(z\) Cylinders -
\(N\) Speed 1/s
\(\dot V_s\) Swept volume rate V_s N/2 m³/s
\(\eta_v\) Volumetric efficiency -

Method and standards

Definition.

Where it is used

  • Engine testing and diagnostics.
  • Examinations.

Common mistakes

  • Forgetting N/2 for four-stroke.
  • Wrong density reference.

Assumptions and limits

  • Four-stroke engine (two-stroke engines are not covered: their swept volume rate is V_s N).
  • With ambient density a value above 100 % shows boost; with manifold density a boosted engine normally reads below 100 %.

References

  • η_v = ṁ_a/(ρ_a V_s N/2) for four-stroke engines

Questions and answers

0.18 kg/s into a 6.23 L engine at 1500 rpm?

About 196 % (above 100 % means boost).

Which density?

Ambient density gives the overall breathing; manifold density the cylinder filling.

Two-stroke?

Uses a different definition (delivery ratio).

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.