Worked example
Example: 10 m coal cone at 35°. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Pile shape | Conical |
| Pile height | 10.000 m |
| Angle of repose | 35.000 ° |
| Windrow length of the straight part | 0 m |
| Bulk density | 850.00 kg/m³ |
Applying the formula below gives:
| Result | Value |
|---|---|
| Base radius (or half-width) | 14.281 m |
| Volume | 2,135.9 m³ |
| Mass | 1,815.5 t |
| Base area | 640.76 m² |
Open this example in the calculator and change any input.
Formula
\(R = \frac{H}{\tan\alpha}, \quad V_{cone} = \frac{\pi R^2H}{3}, \quad V_{windrow} = \frac{\pi R^2H}{3} + RHL\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{shape}\) | Pile shape | - |
| \(H\) | Pile height | m |
| \(\alpha\) | Angle of repose | rad |
| \(L\) | Windrow length of the straight part | m |
| \(\rho_b\) | Bulk density | kg/m³ |
| \(R\) | Base radius (or half-width) | m |
| \(V\) | Volume | m³ |
| \(M\) | Mass | kg |
| \(A_b\) | Base area | m² |
Method and standards
Solid geometry.
Where it is used
- Coal, limestone and biomass yards.
- Stock-taking from survey heights.
Common mistakes
- Ignoring compaction (bulk density rises in deep piles).
- Using the static angle for a moving stacker cone.
Assumptions and limits
- Smooth regular piles on flat ground.
References
- Solid geometry of cones and prisms (definitions)
Questions and answers
Why does angle of repose set the volume?
For a given height, a flatter angle spreads the pile wider, and volume grows with the square of the base radius.
What angles are typical?
Coal 35–40°, limestone 38°, sand 34°, wood chips 40–45°, bagasse up to 50°.
What do the defaults represent?
A 10 m high coal pile at 35° and 850 kg/m³, as a cone or a 100 m windrow.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.