FireCADCalc

Stockpile Volume and Mass: Conical and Windrow Piles

Volume and mass of a conical stockpile or a long windrow (prismatic pile with conical ends) from its height or base and the angle of repose of the material.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: 10 m coal cone at 35°Windrow 8 m high, 38°, 100 m

Results

Live (reclaimable) stock is less than total: for a cone reclaimed through one bottom outlet, often 20–30 % of the pile.

Base radius (or half-width)14.281m
Volume2,135.9m³
Mass1,815.5t
Base area640.76m²

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 10 m coal cone at 35°. The inputs, in the units selected above:

InputValue
Pile shapeConical
Pile height10.000 m
Angle of repose35.000 °
Windrow length of the straight part0 m
Bulk density850.00 kg/m³

Applying the formula below gives:

ResultValue
Base radius (or half-width)14.281 m
Volume2,135.9 m³
Mass1,815.5 t
Base area640.76 m²

Open this example in the calculator and change any input.

Formula

\(R = \frac{H}{\tan\alpha}, \quad V_{cone} = \frac{\pi R^2H}{3}, \quad V_{windrow} = \frac{\pi R^2H}{3} + RHL\)

Variables

Symbol Meaning SI unit
\(\text{shape}\) Pile shape -
\(H\) Pile height m
\(\alpha\) Angle of repose rad
\(L\) Windrow length of the straight part m
\(\rho_b\) Bulk density kg/m³
\(R\) Base radius (or half-width) m
\(V\) Volume m³
\(M\) Mass kg
\(A_b\) Base area m²

Method and standards

Solid geometry.

Where it is used

  • Coal, limestone and biomass yards.
  • Stock-taking from survey heights.

Common mistakes

  • Ignoring compaction (bulk density rises in deep piles).
  • Using the static angle for a moving stacker cone.

Assumptions and limits

  • Smooth regular piles on flat ground.

References

  • Solid geometry of cones and prisms (definitions)

Questions and answers

Why does angle of repose set the volume?

For a given height, a flatter angle spreads the pile wider, and volume grows with the square of the base radius.

What angles are typical?

Coal 35–40°, limestone 38°, sand 34°, wood chips 40–45°, bagasse up to 50°.

What do the defaults represent?

A 10 m high coal pile at 35° and 850 kg/m³, as a cone or a 100 m windrow.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.