FireCADCalc

Chute: Sliding Velocity and Minimum Angle

Velocity of material sliding down an inclined chute from the entry velocity, chute length and angle and the friction coefficient, with the minimum angle for flow.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: 6 m chute at 45°, μ 0.5Bagasse 4 m at 55°, μ 0.7

Results

Sliding-block model with Coulomb friction; it ignores air drag and impact losses. Wet or sticky material can need 10–15° more than the dry friction angle.

Minimum angle for sliding26.565°
Acceleration along the chute3.4672m/s²
Exit velocity6.5273m/s
Time on the chute1.5942s

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 6 m chute at 45°, μ 0.5. The inputs, in the units selected above:

InputValue
Entry velocity1.0000 m/s
Chute length6.0000 m
Chute angle from horizontal45.000 °
Friction coefficient (material on liner)0.50000 -

Applying the formula below gives:

ResultValue
Minimum angle for sliding26.565 °
Acceleration along the chute3.4672 m/s²
Exit velocity6.5273 m/s
Time on the chute1.5942 s

Open this example in the calculator and change any input.

Formula

\(a = g(\sin\theta - \mu\cos\theta), \quad v^2 = v_0^2 + 2aL, \quad \theta_{min} = \arctan\mu\)

Variables

Symbol Meaning SI unit
\(v_0\) Entry velocity m/s
\(L\) Chute length m
\(\theta\) Chute angle from horizontal rad
\(\mu\) Friction coefficient (material on liner) -
\(\theta_{min}\) Minimum angle for sliding rad
\(a\) Acceleration along the chute, in m/s² m/s²
\(v\) Exit velocity m/s
\(t\) Time on the chute s

Method and standards

Inclined-plane dynamics.

Where it is used

  • Transfer chutes and spouts.
  • Bagasse and coal chutes.

Common mistakes

  • Using dry friction for wet material.
  • Ignoring impact energy loss at entry.

Assumptions and limits

  • Sliding as a block.
  • The acceleration is always shown in m/s², whatever the unit system.

References

  • Particle dynamics on an inclined plane with Coulomb friction (definitions)

Questions and answers

What sets the minimum chute angle?

The friction angle: tan θ = μ. Below it material slows and stops.

Why does exit velocity matter?

Too fast causes wear and spillage at the receiving belt; too slow causes blockages.

What do the defaults represent?

Coal entering a 6 m chute at 45° on a steel liner.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.