FireCADCalc

Pitting Resistance Equivalent Number (PREN)

Pitting resistance equivalent number of a stainless steel or nickel alloy from its chromium, molybdenum, tungsten and nitrogen contents, with the 30N variant.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationRefinery and petrochemicalChemical and fertiliserPulp and paper

Inputs

Examples: 2205 duplexSuper duplex with W316L

Results

Rough guide: 304 about 19, 316L about 24, duplex 2205 about 35, super duplex and 6Mo grades above 40. PREN ranks alloys; it does not predict pitting in a given water, which also depends on chloride, temperature and crevices.

PREN (16N)24.730
PREN (30N)25.430

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 2205 duplex. The inputs, in the units selected above:

InputValue
Chromium (wt %)22.000 %
Molybdenum (wt %)3.0000 %
Tungsten (wt %)0 %
Nitrogen (wt %)0.17000 %

Applying the formula below gives:

ResultValue
PREN (16N)34.620
PREN (30N)37.000

Open this example in the calculator and change any input.

Formula

\(PREN = Cr + 3.3(Mo + 0.5W) + 16N\)

Variables

Symbol Meaning SI unit
\(Cr\) Chromium (wt %) -
\(Mo\) Molybdenum (wt %) -
\(W\) Tungsten (wt %) -
\(N\) Nitrogen (wt %) -
\(PREN_{16}\) PREN (16N) -
\(PREN_{30}\) PREN (30N) -

Method and standards

Weighted composition index.

Where it is used

  • Selecting stainless grades for cooling water and seawater.
  • Comparing heats against a minimum PREN.

Common mistakes

  • Using nominal instead of actual heat analysis.
  • Treating PREN as a corrosion rate.

Assumptions and limits

  • Wrought stainless steels and nickel alloys.

References

  • PREN = Cr + 3.3(Mo + 0.5W) + 16N (wt %)
  • the form used in ISO 15156-3 and duplex grade definitions

Questions and answers

What PREN do I need for seawater?

Commonly 40 or more (super duplex, 6Mo austenitic) for ambient seawater without crevice problems.

Why is nitrogen weighted so heavily?

Nitrogen strongly stabilises the passive film in austenite; 16 (or 30 for austenitics) reflects that.

What do the defaults represent?

A 2205 duplex stainless steel: 22 % Cr, 3 % Mo, 0.17 % N.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.