FireCADCalc

Corrosion Rate from Coupon Weight Loss (ASTM G1)

Average corrosion rate of a test coupon in mm per year and mils per year from its mass loss, exposed area, exposure time and density (ASTM G1 form).

Thermal power plantRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: Steel coupon 90 daysCopper coupon 30 days

Results

Average rate assuming uniform loss; inspect the coupon for pits, which the average hides.

Corrosion rate0.002716mm/a
Corrosion rate in mils per year0.10692

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Steel coupon 90 days. The inputs, in the units selected above:

InputValue
Mass loss0.052500 g
Exposed area25.000 cm²
Exposure time90.000 d
Metal density7,860.0 kg/m³

Applying the formula below gives:

ResultValue
Corrosion rate0.010835 mm/a
Corrosion rate in mils per year0.42659

Open this example in the calculator and change any input.

Formula

\(CR = \frac{8.76\times10^4\, W}{A\, T\, D}\)

Variables

Symbol Meaning SI unit
\(W\) Mass loss kg
\(A\) Exposed area m²
\(T\) Exposure time s
\(\rho\) Metal density kg/m³
\(CR\) Corrosion rate (shown in mm/a) m/s
\(CR_{mpy}\) Corrosion rate in mils per year -

Method and standards

ASTM G1.

Where it is used

  • Cooling water and boiler coupon racks.
  • Chemical treatment audits.

Common mistakes

  • Area of one face only.
  • Days for hours.

Assumptions and limits

  • Uniform corrosion.
  • The ASTM G1 constant 8.76 × 10⁴ uses a 365-day year; the mm/a display uses the Julian year (365.25 d). The two differ by 0.07 %, which is negligible.

References

  • ASTM G1: CR = K W/(A T D)
  • K = 8.76 × 10⁴ for mm/y with W in g
  • A in cm²
  • T in h
  • D in g/cm³

Questions and answers

52.5 mg lost from 25 cm² of steel in 90 days?

About 0.011 mm/a (0.4 mpy).

Mils per year?

Thousandths of an inch: 1 mm/a ≈ 39.4 mpy.

Cooling water targets?

Your treatment programme sets them; carbon steel often below 0.075 mm/a (3 mpy).

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.