FireCADCalc

Rounding to Significant Figures and Scientific Notation

Round a number to a chosen number of significant figures or decimal places (half away from zero), and write it in scientific notation.

Inputs

Examples: 0.0045678 to 3 s.f.123456.789 to 2 s.f., 1 d.p.Negative -98.765 to 4 s.f.Very small 1.23456e-30 to 3 s.f.Very large 9.87654e35 to 2 s.f.

Results

The number is outside the exact decimal range (about 10⁻²⁰ to 10²⁷): it was rounded in binary floating point, so the last digit of a value exactly halfway may differ.

Rounded to significant figures9.9000e+35
Rounded to decimal places9.8765e+35
Mantissa (1 ≤ |m| < 10)9.8765
Exponent of ten35.000

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 0.0045678 to 3 s.f.. The inputs, in the units selected above:

InputValue
Number0.004568 -
Significant figures3.0000 -
Decimal places2.0000 -

Applying the formula below gives:

ResultValue
Rounded to significant figures0.004570
Rounded to decimal places0
Mantissa (1 ≤ |m| < 10)4.5678
Exponent of ten-3.0000

Open this example in the calculator and change any input.

Formula

\(x = m \times 10^e, \quad 1 \le |m| < 10\)

Variables

Symbol Meaning SI unit
\(x\) Number -
\(n_s\) Significant figures -
\(n_d\) Decimal places -
\(x_s\) Rounded to significant figures -
\(x_d\) Rounded to decimal places -
\(m\) Mantissa (1 ≤ m < 10) -
\(e\) Exponent of ten -

Method and standards

Definitions.

Where it is used

  • Reporting test results.
  • Examinations.

Common mistakes

  • Leading zeros counted as significant.
  • Rounding twice.

Assumptions and limits

  • Decimal arithmetic between about 10⁻²⁰ and 10²⁷; outside that range the rounding is done in binary floating point and the page says so.

References

  • Decimal rounding
  • half away from zero

Questions and answers

0.0045678 to three significant figures?

0.00457, or 4.5678 × 10⁻³ in scientific notation.

Why significant figures?

Results should not claim more precision than the measurements.

Half to even?

Some software rounds halves to even; this page rounds them away from zero.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.