FireCADCalc

Circular Segment Area, Chord and Arc Length

Area, chord, arc length and central angle of a circular segment from the radius and the segment height, as for the liquid in a horizontal pipe or a cut circle.

Tank and drum

Inputs

Examples: Half circle: R 1 m, h 1 mQuarter depth: R 0.5 m, h 0.25 mThree-quarter full: R 1.2 m, h 1.8 m

Results

Central angle240.00°
Chord length2.0785m
Arc length5.0265m
Segment area3.6395m²
Share of the full circle80.450%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Half circle: R 1 m, h 1 m. The inputs, in the units selected above:

InputValue
Radius1.0000 m
Segment height (sagitta)1.0000 m

Applying the formula below gives:

ResultValue
Central angle180.00 °
Chord length2.0000 m
Arc length3.1416 m
Segment area1.5708 m²
Share of the full circle50.000 %

Open this example in the calculator and change any input.

Formula

\(\theta = 2 \arccos\frac{R - h}{R}, \quad A = \frac{R^2}{2}(\theta - \sin\theta)\)

\(c = 2\sqrt{h(2R - h)}, \quad s = R\,\theta\)

Variables

Symbol Meaning SI unit
\(R\) Radius m
\(h\) Segment height (sagitta) m
\(\theta\) Central angle rad
\(c\) Chord length m
\(s\) Arc length m
\(A\) Segment area m²
\(A/(\pi R^2)\) Share of the full circle -

Method and standards

Plane geometry of the circle.

Where it is used

  • Partly full pipes, drains and horizontal tanks.
  • Arches and bends.
  • Cutting plates.

Common mistakes

  • Using diameter for radius.
  • Angle in degrees in sin θ.

Assumptions and limits

  • Height from 0 to the diameter.

References

  • Circle geometry

Questions and answers

What area is filled in a 1 m diameter pipe to a quarter of its depth?

R 0.5 m, h 0.25 m: area 0.154 m², 19.6 % of the circle, chord 0.866 m.

What is the sagitta?

The height of the segment, from the chord to the arc.

Half full?

Exactly half the area, θ = 180°.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.