FireCADCalc

Arithmetic and Geometric Progressions

nth term and sum of n terms of an arithmetic progression and of a geometric progression, and the sum to infinity of a geometric progression when it converges.

Thermal power plantProcess steam and utilitiesRefinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: AP 2, 5, 8 … and GP ratio 0.5, ten termsAP 100 − 7k and GP ratio 0.9, 15 terms

Results

Geometric series appear in compound interest, decay of oscillations and multiple-effect calculations.

AP nth term2.0000
AP sum of n terms765.00
GP nth term22.877
GP sum of n terms794.11
GP sum to infinity (NaN if it diverges)1,000.0

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: AP 2, 5, 8 … and GP ratio 0.5, ten terms. The inputs, in the units selected above:

InputValue
First term2.0000 -
Common difference (AP)3.0000 -
Common ratio (GP)0.50000 -
Number of terms10.000 -

Applying the formula below gives:

ResultValue
AP nth term29.000
AP sum of n terms155.00
GP nth term0.003906
GP sum of n terms3.9961
GP sum to infinity (NaN if it diverges)4.0000

Open this example in the calculator and change any input.

Formula

\(a_n = a + (n - 1)d, \quad S_n = \frac n2[2a + (n - 1)d], \quad S_n = a\frac{1 - r^n}{1 - r}, \quad S_\infty = \frac{a}{1 - r}\)

Variables

Symbol Meaning SI unit
\(a\) First term -
\(d\) Common difference (AP) -
\(r\) Common ratio (GP) -
\(n\) Number of terms -
\(a_n\) AP nth term -
\(S_n^{AP}\) AP sum of n terms -
\(g_n\) GP nth term -
\(S_n^{GP}\) GP sum of n terms -
\(S_\infty\) GP sum to infinity (NaN if it diverges) -

Method and standards

Series formulae.

Where it is used

  • Exam problems.
  • Preferred number series and escalation.

Common mistakes

  • Using the infinite sum for |r| ≥ 1.
  • Off-by-one in n.

Assumptions and limits

  • Real terms. Geometric terms too large to represent (for example r = 10 with n = 1000) are not shown.

References

  • Arithmetic and geometric series (standard algebra)

Questions and answers

When does a geometric series converge?

When the common ratio lies between −1 and 1; then S∞ = a/(1 − r).

Where do progressions appear in engineering?

Equal increments (AP) in stepped designs; geometric growth in compound interest, gear series and preferred numbers.

What do the defaults represent?

AP 2, 5, 8 … and GP 2, 1, 0.5 … to 10 terms.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.