FireCADCalc

Area and Perimeter of Common Shapes

Area and perimeter of a rectangle, circle, triangle (three sides), isosceles trapezium, ellipse, circular sector or annulus from its dimensions.

Inputs

Examples: Rectangle 3 x 4Circle 2 mTriangle 3-4-5Trapezium 6, 4, height 3Ellipse 3 by 2Sector r 3, 60°Annulus 10 and 6

Results

Annulus perimeter counts both edges.

Area12.000m²
Perimeter14.000m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Rectangle 3 x 4. The inputs, in the units selected above:

InputValue
ShapeRectangle (a × b)
Dimension a3.0000 m
Dimension b4.0000 m
Dimension c5.0000 m
Sector angle57.296 °

Applying the formula below gives:

ResultValue
Area12.000 m²
Perimeter14.000 m

Open this example in the calculator and change any input.

Formula

\(A_{rect} = ab,\ P = 2(a + b); \quad A_{circle} = \frac{\pi a^2}{4},\ P = \pi a\ (a = \text{diameter}); \quad A_{trap} = \frac{a + b}{2}c,\ P = a + b + 2\sqrt{c^2 + \left(\frac{a - b}{2}\right)^2}\)

\(A_{sector} = \frac{a^2\theta}{2},\ P = 2a + a\theta\ (a = \text{radius}); \quad A_{annulus} = \frac{\pi(a^2 - b^2)}{4},\ P = \pi(a + b)\ (a, b = \text{diameters}); \quad A_{ellipse} = \pi ab\)

\(A_\triangle = \sqrt{s(s - a)(s - b)(s - c)}, \quad P_{ellipse} \approx \pi(a + b)\left(1 + \frac{3h}{10 + \sqrt{4 - 3h}}\right), \ h = \frac{(a - b)^2}{(a + b)^2}\)

Variables

Symbol Meaning SI unit
\(\text{shape}\) Shape -
\(a\) Dimension a m
\(b\) Dimension b m
\(c\) Dimension c m
\(\theta\) Sector angle rad
\(A\) Area m²
\(P\) Perimeter m

Method and standards

Plane geometry.

Where it is used

  • Plate, gasket and cut-out areas.
  • Examinations.

Common mistakes

  • Diameter vs radius.
  • Degrees in sector formulas.

Assumptions and limits

  • Plane figures.

References

  • Plane geometry; Heron's formula; Ramanujan (1914) ellipse perimeter approximation

Questions and answers

Triangle 3, 4, 5?

Area 6, perimeter 12.

Ellipse 3 by 2?

Area 18.850, perimeter about 15.865.

Sector of 60° and radius 3?

Area 4.712.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.