FireCADCalc

Reinforcement Quantity from kg per m³ of Concrete

Reinforcing steel quantity from concrete volumes and typical kg per cubic metre for each member type, for early estimates before detailing.

Inputs

Examples: Typical frameFootings onlyNo concrete

Results

The ratios are your own or your firm's past figures; the defaults are only placeholders for a typical frame.

Total steel2.0000t
Total concrete40.000m³
Average steel per m³50.000kg/m³

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Typical frame. The inputs, in the units selected above:

InputValue
Concrete in footings17.500 m³
Steel ratio in footings60.000 kg/m³
Concrete in columns5.8000 m³
Steel ratio in columns180.00 kg/m³
Concrete in beams7.3000 m³
Steel ratio in beams130.00 kg/m³
Concrete in slabs27.000 m³
Steel ratio in slabs80.000 kg/m³

Applying the formula below gives:

ResultValue
Total steel5.2030 t
Total concrete57.600 m³
Average steel per m³90.330 kg/m³

Open this example in the calculator and change any input.

Formula

\(m = \sum V_i\, r_i, \quad \bar r = \frac{m}{\sum V_i}\)

Variables

Symbol Meaning SI unit
\(V_f\) Concrete in footings m³
\(r_f\) Steel ratio in footings kg/m³
\(V_c\) Concrete in columns m³
\(r_c\) Steel ratio in columns kg/m³
\(V_b\) Concrete in beams m³
\(r_b\) Steel ratio in beams kg/m³
\(V_s\) Concrete in slabs m³
\(r_s\) Steel ratio in slabs kg/m³
\(m\) Total steel kg
\(V\) Total concrete m³
\(\bar r\) Average steel per m³ kg/m³

Method and standards

Weighted sum.

Where it is used

  • Early cost estimates.
  • Checking detailed quantities.

Common mistakes

  • Using one ratio for all members.
  • Ratios from different design codes.

Assumptions and limits

  • Estimate only.

References

  • Volume × steel ratio (Common site practice (quantity estimating))

Questions and answers

What do the defaults give?

About 5.2 t of steel for 57.6 m³ of concrete, about 90 kg/m³ on average.

Where do ratios come from?

Completed projects of the same type; detailing gives the real figure.

Why are columns highest?

They carry heavy longitudinal bars and close ties.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.