FireCADCalc

Engine Mechanical Efficiency and Friction Power

Friction power and mechanical efficiency of an engine from indicated and brake power, with the indicated thermal efficiency from the fuel heat.

Boiler operation engineer (BOE) examinations

Inputs

Examples: 62 / 50 kWNo fuel figure

Results

No fuel heat input entered; the indicated thermal efficiency is not shown.

Friction power IP − BP22.000kW
Mechanical efficiency BP/IP81.667%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 62 / 50 kW. The inputs, in the units selected above:

InputValue
Indicated power62.000 kW
Brake power50.000 kW
Fuel heat input (0 to skip)147.60 kW

Applying the formula below gives:

ResultValue
Friction power IP − BP12.000 kW
Mechanical efficiency BP/IP80.645 %
Indicated thermal efficiency42.005 %

Open this example in the calculator and change any input.

Formula

\(FP = IP - BP, \quad \eta_m = \frac{BP}{IP}, \quad \eta_{it} = \frac{IP}{\dot Q_f}\)

Variables

Symbol Meaning SI unit
\(IP\) Indicated power W
\(BP\) Brake power W
\(\dot Q_f\) Fuel heat input (0 to skip) W
\(FP\) Friction power IP − BP W
\(\eta_m\) Mechanical efficiency BP/IP -
\(\eta_{it}\) Indicated thermal efficiency -

Method and standards

Definitions.

Where it is used

  • Engine testing.
  • BOE and engineering examinations.

Common mistakes

  • Brake efficiency for indicated.
  • Mixing units.

Assumptions and limits

  • Steady running.

References

  • η_m = BP/IP; FP = IP − BP

Questions and answers

62 kW indicated, 50 kW brake?

Friction 12 kW: mechanical efficiency 80.6 %.

Indicated power?

From an indicator diagram or the Morse test.

Part load?

Friction stays about constant, so η_m falls.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.