FireCADCalc

Air-Standard Otto and Diesel Cycle Efficiency

Air-standard efficiency of the Otto and Diesel cycles from compression ratio, cut-off ratio and the ratio of specific heats.

Inputs

Examples: r 16, cut-off 2Petrol r 9, cut-off 1.5

Results

Ideal cycles with cold air; real engines reach well under these values.

Otto efficiency at r58.476%
Diesel efficiency at r and r_c54.672%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: r 16, cut-off 2. The inputs, in the units selected above:

InputValue
Compression ratio16.000 -
Cut-off ratio (Diesel)2.0000 -
Ratio of specific heats1.4000 -

Applying the formula below gives:

ResultValue
Otto efficiency at r67.012 %
Diesel efficiency at r and r_c61.380 %

Open this example in the calculator and change any input.

Formula

\(\eta_{Otto} = 1 - \frac{1}{r^{\gamma - 1}}, \quad \eta_{Diesel} = 1 - \frac{1}{r^{\gamma - 1}}\cdot\frac{r_c^\gamma - 1}{\gamma(r_c - 1)}\)

Variables

Symbol Meaning SI unit
\(r\) Compression ratio -
\(r_c\) Cut-off ratio (Diesel) -
\(\gamma\) Ratio of specific heats -
\(\eta_{Otto}\) Otto efficiency at r -
\(\eta_{Diesel}\) Diesel efficiency at r and r_c -

Method and standards

Air-standard analysis.

Where it is used

  • Engine theory.
  • BOE and engineering examinations.

Common mistakes

  • Using cut-off ratio in Otto.
  • Hot-air γ for cold-air tables.

Assumptions and limits

  • Ideal gas, reversible processes.

References

  • Air-standard cycles: η_Otto = 1 − r^(1−γ); η_Diesel = 1 − r^(1−γ)(r_c^γ − 1)/(γ(r_c − 1))

Questions and answers

r 16, cut-off 2?

Otto 67.0 %, Diesel 61.4 %.

Why is Diesel lower at the same r?

Heat is added at constant pressure, partly at lower temperature.

Then why diesels?

They run at much higher compression ratios.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.