FireCADCalc

Spring–Mass Natural Frequency and Static Deflection

Undamped natural frequency of a spring–mass system from stiffness and mass, its static deflection, and the frequency found from a measured deflection.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: 500 kg on 200 kN/mLight 20 kg on 50 kN/m

Results

f_n = (1/2π)√(g/δ) is handy on site: a 5 mm static sag means about 7 Hz.

Natural circular frequency (rad/s)50.000
Natural frequency7.9577Hz
Static deflection mg/k3.9227mm
Frequency from the measured deflection11.145Hz

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 500 kg on 200 kN/m. The inputs, in the units selected above:

InputValue
Spring stiffness200.00 kN/m
Mass500.00 kg
Measured static deflection (for the check)5.0000 mm

Applying the formula below gives:

ResultValue
Natural circular frequency (rad/s)20.000
Natural frequency3.1831 Hz
Static deflection mg/k24.517 mm
Frequency from the measured deflection7.0485 Hz

Open this example in the calculator and change any input.

Formula

\(\omega_n = \sqrt{\frac km}, \quad f_n = \frac{\omega_n}{2\pi}, \quad \delta_{st} = \frac{mg}{k}, \quad f_n = \frac{1}{2\pi}\sqrt{\frac{g}{\delta_{st}}}\)

Variables

Symbol Meaning SI unit
\(k\) Spring stiffness N/m
\(m\) Mass kg
\(\delta_{st}\) Measured static deflection (for the check) m
\(\omega_n\) Natural circular frequency (rad/s) -
\(f_n\) Natural frequency 1/s
\(\delta\) Static deflection mg/k m
\(f_{n,\delta}\) Frequency from the measured deflection 1/s
\(g\) Standard gravity, 9.806 65 m/s²

Method and standards

Single degree of freedom.

Where it is used

  • Machine mounting and foundations.
  • Checking resonance against running speed.

Common mistakes

  • Using mass in kgf.
  • Ignoring the mass of the spring.

Assumptions and limits

  • Linear spring; undamped.

References

  • Rao
  • Mechanical Vibrations
  • 6th ed. (Pearson, 2017)
  • ch. 2

Questions and answers

Why does static deflection give frequency?

Both depend on k/m: δ = mg/k, so ω_n = √(g/δ).

How do I lower a natural frequency?

Softer springs or more mass.

What do the defaults represent?

A 500 kg machine on mounts of 200 kN/m total stiffness.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.