Worked example
Example: 500 kg on 200 kN/m. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Spring stiffness | 200.00 kN/m |
| Mass | 500.00 kg |
| Measured static deflection (for the check) | 5.0000 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Natural circular frequency (rad/s) | 20.000 |
| Natural frequency | 3.1831 Hz |
| Static deflection mg/k | 24.517 mm |
| Frequency from the measured deflection | 7.0485 Hz |
Open this example in the calculator and change any input.
Formula
\(\omega_n = \sqrt{\frac km}, \quad f_n = \frac{\omega_n}{2\pi}, \quad \delta_{st} = \frac{mg}{k}, \quad f_n = \frac{1}{2\pi}\sqrt{\frac{g}{\delta_{st}}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(k\) | Spring stiffness | N/m |
| \(m\) | Mass | kg |
| \(\delta_{st}\) | Measured static deflection (for the check) | m |
| \(\omega_n\) | Natural circular frequency (rad/s) | - |
| \(f_n\) | Natural frequency | 1/s |
| \(\delta\) | Static deflection mg/k | m |
| \(f_{n,\delta}\) | Frequency from the measured deflection | 1/s |
| \(g\) | Standard gravity, 9.806 65 | m/s² |
Method and standards
Single degree of freedom.
Where it is used
- Machine mounting and foundations.
- Checking resonance against running speed.
Common mistakes
- Using mass in kgf.
- Ignoring the mass of the spring.
Assumptions and limits
- Linear spring; undamped.
References
- Rao
- Mechanical Vibrations
- 6th ed. (Pearson, 2017)
- ch. 2
Questions and answers
Why does static deflection give frequency?
Both depend on k/m: δ = mg/k, so ω_n = √(g/δ).
How do I lower a natural frequency?
Softer springs or more mass.
What do the defaults represent?
A 500 kg machine on mounts of 200 kN/m total stiffness.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.