FireCADCalc

Mean, Standard Deviation and Coefficient of Variation

Mean, sample and population standard deviation, coefficient of variation, minimum, maximum and range of up to eight values.

Inputs

Examples: Six cube resultsEight GCV results

Results

Mean4,114.1
Sample standard deviation (n − 1)26.670
Population standard deviation (n)24.947
Coefficient of variation s/x̄0.64824%
Minimum4,076.0
Maximum4,150.0

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Six cube results. The inputs, in the units selected above:

InputValue
Number of values used6.0000 -
Value 131.200 -
Value 229.800 -
Value 332.500 -
Value 430.100 -
Value 533.000 -
Value 628.900 -
Value 70 -
Value 80 -

Applying the formula below gives:

ResultValue
Mean30.917
Sample standard deviation (n − 1)1.6068
Population standard deviation (n)1.4668
Coefficient of variation s/x̄5.1971 %
Minimum28.900
Maximum33.000

Open this example in the calculator and change any input.

Formula

\(\bar x = \frac{1}{n}\sum x_i, \quad s = \sqrt{\frac{\sum(x_i - \bar x)^2}{n - 1}}\)

Variables

Symbol Meaning SI unit
\(n\) Number of values used -
\(x_{1}\) Value 1 -
\(x_{2}\) Value 2 -
\(x_{3}\) Value 3 -
\(x_{4}\) Value 4 -
\(x_{5}\) Value 5 -
\(x_{6}\) Value 6 -
\(x_{7}\) Value 7 -
\(x_{8}\) Value 8 -
\(\bar x\) Mean -
\(s\) Sample standard deviation (n − 1) -
\(\sigma\) Population standard deviation (n) -
\(CV\) Coefficient of variation s/x̄ -
\(x_{min}\) Minimum -
\(x_{max}\) Maximum -

Method and standards

Descriptive statistics.

Where it is used

  • Test result analysis (cubes, coal samples, meter checks).
  • Quality control.

Common mistakes

  • Population SD for small samples.
  • Including blank fields.

Assumptions and limits

  • Independent values.
  • With a zero mean the coefficient of variation is not defined and is not shown.

References

  • Descriptive statistics; sample SD with n − 1 (Bessel)

Questions and answers

Six cube results 31.2 … 28.9 MPa?

Mean 30.92, sample SD 1.61.

Sample or population?

Sample (n − 1) when the values are a sample of a larger lot.

CV?

SD relative to the mean: compares spreads of different sizes.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.