FireCADCalc

Number of Tubes for a Heat Transfer Area

Number of tubes in a shell-and-tube exchanger for a required area from tube outside diameter, length and passes, rounded up to a whole number per pass.

Refinery and petrochemicalChemical and fertiliser

Inputs

Examples: 85 m2, 3/4 in, 16 ft, 2 passes40 m2, 25 mm, 6 m, 4 passes

Results

Shell size follows from the tube count, pitch and layout tables of your design method.

Tubes for the area (exact)291.04
Tubes, rounded up to a multiple of the passes292.00
Tubes per pass146.00
Area provided85.280m²

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 85 m2, 3/4 in, 16 ft, 2 passes. The inputs, in the units selected above:

InputValue
Heat transfer area needed85.000 m²
Tube outside diameter19.050 mm
Effective tube length4.8800 m
Tube passes2.0000 -

Applying the formula below gives:

ResultValue
Tubes for the area (exact)291.04
Tubes, rounded up to a multiple of the passes292.00
Tubes per pass146.00
Area provided85.280 m²

Open this example in the calculator and change any input.

Formula

\(N = \frac{A}{\pi d_o L}\)

Variables

Symbol Meaning SI unit
\(A\) Heat transfer area needed m²
\(d_o\) Tube outside diameter m
\(L\) Effective tube length m
\(n_p\) Tube passes -
\(N_0\) Tubes for the area (exact) -
\(N\) Tubes, rounded up to a multiple of the passes -
\(N/n_p\) Tubes per pass -
\(A_{act}\) Area provided m²

Method and standards

Geometry.

Where it is used

  • Exchanger sizing and checking.
  • Retubing.

Common mistakes

  • Inside diameter with outside-based U.
  • Tube sheet length included.

Assumptions and limits

  • Straight tubes.

References

  • A = N π d_o L

Questions and answers

85 m² with ¾-inch tubes 16 ft long, two passes?

291.0 tubes: 292 rounded to two passes.

Why outside diameter?

Areas are usually quoted on the outside of the tubes.

Effective length?

Length between tube sheets, less the tube sheet thickness.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.