Worked example
Example: Duda's example: 13 ft 6 in x 190 ft preheater kiln, 1,600,000 lb. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Total vertical load on all roller shaft bearings | 725.75 t |
| Roller shaft bearing diameter | 406.40 mm |
| Riding ring (tyre) diameter | 4,419.6 mm |
| Support roller diameter | 1,066.8 mm |
| Kiln speed | 1.7000 rpm |
| Roller bearings | Oil-lubricated (F = 0.018) |
| Kiln diameter inside the lining | 3.5052 m |
| Degree of filling | 12.000 % |
| Kiln length | 57.912 m |
| Material | Cement, wet or dry (35° repose) |
Applying the formula below gives:
| Result | Value |
|---|---|
| sin θ from the filling | 0.76425 |
| Friction power | 22.265 kW |
| Load power | 124.27 kW |
| Total drive power | 146.54 kW |
Open this example in the calculator and change any input.
Formula
\(HP_f = \frac{W\,b_d\,t_d\,N\,F\,0.0000092}{r_d}, \quad HP_l = (D\sin\Theta)^3 N L K, \quad \frac{2\Theta - \sin2\Theta}{2\pi} = f\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(W\) | Total vertical load on all roller shaft bearings | kg |
| \(b_d\) | Roller shaft bearing diameter | m |
| \(t_d\) | Riding ring (tyre) diameter | m |
| \(r_d\) | Support roller diameter | m |
| \(N\) | Kiln speed | 1/s |
| \(F\) | Roller bearings | - |
| \(D\) | Kiln diameter inside the lining | m |
| \(f\) | Degree of filling | - |
| \(L\) | Kiln length | m |
| \(K\) | Material | - |
| \(\sin\Theta\) | sin θ from the filling | - |
| \(P_f\) | Friction power | W |
| \(P_l\) | Load power | W |
| \(P\) | Total drive power | W |
Method and standards
Friction and load horsepower.
Where it is used
- Selecting kiln drives.
- Checking drives for a speed increase.
Common mistakes
- Using the shell diameter for D.
- Forgetting multi-diameter kilns need each section separately.
Assumptions and limits
- Imperial formula; uniform bed.
References
- Duda
- Cement Data Book
- Vol. 1
- 3rd ed. (Bauverlag / Macdonald and Evans, 1985)
- sec. 19.1.6 and its worked example
Questions and answers
Why two terms?
One overcomes friction in the support-roller bearings, the other lifts the off-centre bed as the kiln turns.
How good is the estimate?
Duda's example gives 200 HP for a 13′6″ × 190 ft preheater kiln, which is what such kilns were fitted with (150 kW).
What do the defaults represent?
Duda's example: 1,600,000 lb on the rollers, 16 in roller shafts, 174 in tyres, 42 in rollers, 1.7 rpm, 11.5 ft inside lining, 12 % filling, 190 ft.
Method and article reviewed by FireCAD engineering on 17 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.