FireCADCalc

Air–Fuel Ratio, Excess Air and Equivalence Ratio

Air–fuel ratio from measured air and fuel flows, compared with the stoichiometric ratio, giving lambda (excess air) and the equivalence ratio.

Inputs

Examples: Diesel at part loadLean-burn gas engine

About 14.5 for diesel, 14.7 for petrol, 17.2 for methane.

Results

Air–fuel ratio29.455
Lambda AFR/AFR_s2.0313
Equivalence ratio 1/λ0.49228
Excess air (λ − 1)103.13%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Diesel at part load. The inputs, in the units selected above:

InputValue
Air flow648.00 kg/h
Fuel flow22.000 kg/h
Stoichiometric air–fuel ratio14.500 -

Applying the formula below gives:

ResultValue
Air–fuel ratio29.455
Lambda AFR/AFR_s2.0313
Equivalence ratio 1/λ0.49228
Excess air (λ − 1)103.13 %

Open this example in the calculator and change any input.

Formula

\(AFR = \frac{\dot m_a}{\dot m_f}, \quad \lambda = \frac{AFR}{AFR_s}, \quad \phi = \frac{1}{\lambda}\)

Variables

Symbol Meaning SI unit
\(\dot m_a\) Air flow kg/s
\(\dot m_f\) Fuel flow kg/s
\(AFR_s\) Stoichiometric air–fuel ratio -
\(AFR\) Air–fuel ratio -
\(\lambda\) Lambda AFR/AFR_s -
\(\phi\) Equivalence ratio 1/λ -
\(EA\) Excess air (λ − 1) -

Method and standards

Definitions.

Where it is used

  • Engine tuning and emissions.
  • Burner and boiler analogies.

Common mistakes

  • Volume instead of mass flows.
  • Wrong stoichiometric ratio for the fuel.

Assumptions and limits

  • Steady running.
  • A negative excess air (λ < 1, rich) is the air deficiency; with no air flow φ is not shown.

References

  • AFR = ṁ_a/ṁ_f; λ = AFR/AFR_s; φ = 1/λ

Questions and answers

0.18 kg/s of air with 22 kg/h of diesel?

AFR 29.5: λ 2.03.

Why do diesels run lean?

They control load by fuel alone, with excess air at part load.

Gas engines?

Lean-burn engines run near λ 1.8–2.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.