FireCADCalc

Pipe Volume, Contents and Fill or Drain Time

Internal volume of a pipeline from its bore and length, the mass of its contents, and the time to fill or drain it at a flow, for commissioning and hydrotests.

Thermal power plantProcess steam and utilitiesRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: 500 m of 200 mm at 30 m³/h2 km of 600 mm at 300 m³/hTubing 50 m of 10 mm at 1 L/min

Results

Volume per metre0.078540L
Total volume0.003927m³
Mass of contents3.9191kg
Fill or drain time3.9270min

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 500 m of 200 mm at 30 m³/h. The inputs, in the units selected above:

InputValue
Inside diameter200.00 mm
Length500.00 m
Contents density998.00 kg/m³
Fill or drain flow30.000 m³/h

Applying the formula below gives:

ResultValue
Volume per metre31.416 L
Total volume15.708 m³
Mass of contents15,677 kg
Fill or drain time31.416 min

Open this example in the calculator and change any input.

Formula

\(V = \frac{\pi d^2}{4} L, \quad t = \frac{V}{Q}\)

Variables

Symbol Meaning SI unit
\(d\) Inside diameter m
\(L\) Length m
\(\rho\) Contents density kg/m³
\(Q\) Fill or drain flow m³/s
\(V'\) Volume per metre m³
\(V\) Total volume m³
\(m\) Mass of contents kg
\(t\) Fill or drain time s

Method and standards

Geometry.

Where it is used

  • Hydrotests and flushing.
  • Chemical cleaning volumes.

Common mistakes

  • Using outside diameter.
  • Forgetting fittings and equipment volumes.

Assumptions and limits

  • Uniform bore.
  • Constant flow: gravity draining slows as the head falls, so a gravity drain takes longer than V/Q at the starting flow.

References

  • V = π d² L / 4

Questions and answers

How much water in 500 m of 200 mm pipe?

15.7 m³ (31.4 L per metre).

How long to fill at 30 m³/h?

About 31 minutes.

Why fill slowly?

To vent air and avoid surge; high points need vents.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.