Worked example
Example: 500 m of 200 mm at 30 m³/h. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Inside diameter | 200.00 mm |
| Length | 500.00 m |
| Contents density | 998.00 kg/m³ |
| Fill or drain flow | 30.000 m³/h |
Applying the formula below gives:
| Result | Value |
|---|---|
| Volume per metre | 31.416 L |
| Total volume | 15.708 m³ |
| Mass of contents | 15,677 kg |
| Fill or drain time | 31.416 min |
Open this example in the calculator and change any input.
Formula
\(V = \frac{\pi d^2}{4} L, \quad t = \frac{V}{Q}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(d\) | Inside diameter | m |
| \(L\) | Length | m |
| \(\rho\) | Contents density | kg/m³ |
| \(Q\) | Fill or drain flow | m³/s |
| \(V'\) | Volume per metre | m³ |
| \(V\) | Total volume | m³ |
| \(m\) | Mass of contents | kg |
| \(t\) | Fill or drain time | s |
Method and standards
Geometry.
Where it is used
- Hydrotests and flushing.
- Chemical cleaning volumes.
Common mistakes
- Using outside diameter.
- Forgetting fittings and equipment volumes.
Assumptions and limits
- Uniform bore.
- Constant flow: gravity draining slows as the head falls, so a gravity drain takes longer than V/Q at the starting flow.
References
- V = π d² L / 4
Questions and answers
How much water in 500 m of 200 mm pipe?
15.7 m³ (31.4 L per metre).
How long to fill at 30 m³/h?
About 31 minutes.
Why fill slowly?
To vent air and avoid surge; high points need vents.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.