Worked example
Example: 23/71 teeth at 1 480 rpm, 200 mm pulley, 2 m belt, 6 vanes. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Driving shaft speed | 1,480.0 rpm |
| Teeth on the driving gear | 23.000 - |
| Teeth on the driven gear | 71.000 - |
| Driving pulley pitch diameter | 200.00 mm |
| Belt length | 2.0000 m |
| Vanes or blades on the impeller | 6.0000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Gear mesh frequency z₁ f₁ | 567.33 Hz |
| Driven shaft speed | 479.44 rpm |
| Hunting tooth frequency | 0.34742 Hz |
| Belt pass frequency | 7.7493 Hz |
| Vane or blade pass frequency (on the driving shaft) | 148.00 Hz |
Open this example in the calculator and change any input.
Formula
\(GMF = z_1 f_1, \quad f_2 = f_1\frac{z_1}{z_2}, \quad f_{ht} = \frac{GMF\, \gcd(z_1, z_2)}{z_1 z_2}, \quad f_b = \frac{\pi D_p f_1}{L_b}, \quad f_v = n_b f_1\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(f_1\) | Driving shaft speed | 1/s |
| \(z_1\) | Teeth on the driving gear | - |
| \(z_2\) | Teeth on the driven gear | - |
| \(D_p\) | Driving pulley pitch diameter | m |
| \(L_b\) | Belt length | m |
| \(n_b\) | Vanes or blades on the impeller | - |
| \(GMF\) | Gear mesh frequency z₁ f₁ | 1/s |
| \(f_2\) | Driven shaft speed | 1/s |
| \(f_{ht}\) | Hunting tooth frequency | 1/s |
| \(f_b\) | Belt pass frequency | 1/s |
| \(f_v\) | Vane or blade pass frequency (on the driving shaft) | 1/s |
Method and standards
Kinematics of gears, belts and impellers.
Where it is used
- Vibration analysis.
- Gearbox and fan diagnosis.
Common mistakes
- Using rpm instead of Hz.
- Belt frequency from the wrong pulley.
Assumptions and limits
- No slip. Tooth and blade counts must be whole numbers.
- The blade-pass and belt frequencies use the driving shaft speed f₁: if the impeller is on the driven shaft (after the gear or belt), enter that shaft's speed; the belt pass assumes the pitch diameter is on the driving pulley.
References
- Machinery vibration kinematics (gear mesh z f, belt π D f / L, blade pass n f)
Questions and answers
23 and 71 teeth at 1480 rpm: what mesh frequency?
567.3 Hz; the driven shaft turns at 479.4 rpm.
What is the hunting tooth frequency?
How often the same pair of teeth meet: GMF × (common factors)/(z₁ z₂).
Why blade pass?
A peak there points to flow problems or rubbing in pumps and fans.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.