Worked example
Example: 30 kPa valve, 70 kPa circuit, half open, R 50. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Pressure drop across the fully open valve | 30.000 kPa |
| Pressure drop in the rest of the circuit at design flow | 70.000 kPa |
| Valve travel | 50.000 % |
| Rangeability (equal percentage) | 50.000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Valve authority Δp_v / (Δp_v + Δp_s) | 30.000 % |
| Installed flow share, linear valve | 72.548 % |
| Installed flow share, equal-percentage valve | 25.238 % |
Open this example in the calculator and change any input.
Formula
\(N = \frac{\Delta p_v}{\Delta p_v + \Delta p_s}, \quad q = \frac{1}{\sqrt{N/f^2 + (1 - N)}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\Delta p_v\) | Pressure drop across the fully open valve | Pa |
| \(\Delta p_s\) | Pressure drop in the rest of the circuit at design flow | Pa |
| \(x\) | Valve travel | - |
| \(R\) | Rangeability (equal percentage) | - |
| \(N\) | Valve authority Δp_v / (Δp_v + Δp_s) | - |
| \(q_{lin}\) | Installed flow share, linear valve | - |
| \(q_{eq}\) | Installed flow share, equal-percentage valve | - |
Method and standards
Valve and circuit resistances in series.
Where it is used
- HVAC and process valve selection.
- Diagnosing poor control.
Common mistakes
- Using the valve DP at part load.
- Oversized valves.
Assumptions and limits
The 0.25 lower limit flagged on the page is a common rule of thumb for acceptable control (many HVAC designers aim for 0.5); it is practice, not a figure from a standard.
Constant total ΔP.
References
- Valve authority and installed characteristic (CIBSE Guide H; series flow resistance)
Questions and answers
30 kPa across the valve, 70 kPa in the rest?
Authority 0.3.
What flow at half travel?
Linear valve 73 % of full flow; equal percentage 25 %.
Why does authority matter?
With low authority most of the travel does little, then flow rises sharply near full open.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.