Worked example
Example: 1200 kN on 200 kPa, square. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Column load (service) | 1,200.0 kN |
| Allowance for footing and soil weight | 10.000 % |
| Safe (allowable) bearing capacity | 200.00 kPa |
| Length to width ratio | 1.0000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Area required | 6.6000 m² |
| Width | 2.5690 m |
| Length | 2.5690 m |
| Net upward soil pressure under service load P/(BL) | 181.82 kPa |
Open this example in the calculator and change any input.
Formula
\(A = \frac{P(1 + k_{sw})}{q_a}, \quad B = \sqrt{\frac{A}{L/B}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(P\) | Column load (service) | N |
| \(k_{sw}\) | Allowance for footing and soil weight | - |
| \(q_a\) | Safe (allowable) bearing capacity | Pa |
| \(L/B\) | Length to width ratio | - |
| \(A\) | Area required | m² |
| \(B\) | Width | m |
| \(L\) | Length | m |
| \(q_n\) | Net upward soil pressure under service load P/(BL) (not the ultimate bearing capacity q_u) | Pa |
Method and standards
Area from allowable pressure.
Where it is used
- Column and equipment footings.
- Quick foundation estimates.
Common mistakes
- Ultimate instead of safe bearing capacity.
- Forgetting self-weight.
Assumptions and limits
- Concentric load; service (unfactored) load. q_n is the net upward pressure for the footing's structural design under service load; limit-state design uses the factored load.
References
- A = P(1 + k)/q_a (foundation design practice)
Questions and answers
1200 kN with 10 % self-weight on 200 kPa soil?
6.6 m²: a square of 2.57 m, say 2.6 m.
Why add self-weight?
The soil carries the footing and backfill too.
And the factored design?
The net upward pressure from the service load is the usual start; factor it per your code.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.