FireCADCalc

Buffer pH (Henderson–Hasselbalch)

pH of a buffer from the pKa and the concentrations of the weak acid and its conjugate base, and the base-to-acid ratio for a target pH.

Refinery and petrochemicalChemical and fertiliserFood, dairy and textile

Inputs

Examples: Acetate 0.1/0.15 MPhosphate pKa 7.2

Results

Valid for buffers well within about one pH unit of the pKa and not too dilute.

Buffer pH4.9361
Ratio needed for the target pH1.7378

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Acetate 0.1/0.15 M. The inputs, in the units selected above:

InputValue
pKa of the weak acid4.7600 -
Weak acid concentration0.10000 mol/L
Conjugate base concentration0.15000 mol/L
Target pH5.0000 -

Applying the formula below gives:

ResultValue
Buffer pH4.9361
Ratio needed for the target pH1.7378

Open this example in the calculator and change any input.

Formula

\(pH = pK_a + \log_{10}\frac{[A^-]}{[HA]}\)

Variables

Symbol Meaning SI unit
\(pK_a\) pKa of the weak acid -
\([HA]\) Weak acid concentration mol/m³
\([A^-]\) Conjugate base concentration mol/m³
\(pH_t\) Target pH -
\(pH\) Buffer pH -
\([A^-]/[HA]\) Ratio needed for the target pH -

Method and standards

Henderson–Hasselbalch.

Where it is used

  • Laboratory buffers for water analysis.
  • Process pH control.

Common mistakes

  • Using it for strong acids.
  • pKa at the wrong temperature.

Assumptions and limits

  • Dilute ideal solution. Notes appear when the buffer or target pH is more than one unit from the pKa.

References

  • Henderson–Hasselbalch pH = pKa + log([A⁻]/[HA])

Questions and answers

Acetic acid 0.1 M with acetate 0.15 M?

pH 4.94.

For pH 5.0?

Base-to-acid ratio 1.74.

Why within one pH unit?

Outside it the buffer has little capacity and the approximation weakens.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.