FireCADCalc

Theoretical Final Molasses % Cane

Final molasses expected per tonne of cane from the non-sugars in clear juice and the brix and pol of final molasses, and the pol it carries.

Sugar mill and cogenerationDistillery and ethanol

Inputs

Examples: TypicalLow purity molasses

Results

Assumes every non-sugar in clear juice ends in final molasses.

Non-sugars % final molasses56.000%
Final molasses % cane4.1964%
Pol lost in final molasses % cane1.3429%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Typical. The inputs, in the units selected above:

InputValue
Non-sugars in clear juice % cane2.3500 %
Brix % final molasses88.000 %
Pol % final molasses32.000 %

Applying the formula below gives:

ResultValue
Non-sugars % final molasses56.000 %
Final molasses % cane4.1964 %
Pol lost in final molasses % cane1.3429 %

Open this example in the calculator and change any input.

Formula

\(FM_c = \frac{NS_{CJ,c}}{Bx_{FM} - Pol_{FM}}, \quad Pol_{FM,c} = FM_c\,Pol_{FM}\)

Variables

Symbol Meaning SI unit
\(NS_{CJ,c}\) Non-sugars in clear juice % cane -
\(Bx_{FM}\) Brix % final molasses -
\(Pol_{FM}\) Pol % final molasses -
\(NS_{FM}\) Non-sugars % final molasses -
\(FM_c\) Final molasses % cane -
\(Pol_{FM,c}\) Pol lost in final molasses % cane -

Method and standards

Non-sugar balance.

Where it is used

  • Daily manufacturing report.
  • Molasses for the distillery.

Common mistakes

  • Using mixed juice non-sugars.

Assumptions and limits

  • Non-sugars conserved.

References

  • Sugar factory chemical control (daily manufacturing report) definitions
  • as compiled in SugarProcessTech
  • Formulas for calculating sugar industry DMR

Questions and answers

Why theoretical?

It assumes non-sugars pass unchanged to molasses; actual weighed molasses checks it.

What lowers molasses % cane?

Better clarification and a lower final molasses purity.

Is molasses a loss?

For the sugar house yes; for a distillery it is the feedstock.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.