FireCADCalc

Sugar Factory Pol Balance and Unknown Losses

Pol in sugar % cane, total, determined and unknown losses from pol % cane, the losses in bagasse, filter cake and final molasses, and sugar made.

Sugar mill and cogeneration

Inputs

Examples: TypicalOverstated molasses

Results

Pol in sugar % cane11.166%
Total losses % cane2.3336%
Determined losses % cane2.0500%
Unknown losses % cane0.28360%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Typical. The inputs, in the units selected above:

InputValue
Pol % cane13.500 %
Pol in bagasse % cane0.52000 %
Pol in filter cake % cane0.080000 %
Pol in final molasses % cane1.4500 %
Sugar made % cane11.200 %
Pol % sugar99.700 %

Applying the formula below gives:

ResultValue
Pol in sugar % cane11.166 %
Total losses % cane2.3336 %
Determined losses % cane2.0500 %
Unknown losses % cane0.28360 %

Open this example in the calculator and change any input.

Formula

\(L_t = Pol_c - Pol_S\,R, \quad L_u = L_t - (L_B + L_{FC} + L_{FM})\)

Variables

Symbol Meaning SI unit
\(Pol_c\) Pol % cane -
\(L_B\) Pol in bagasse % cane -
\(L_{FC}\) Pol in filter cake % cane -
\(L_{FM}\) Pol in final molasses % cane -
\(R\) Sugar made % cane -
\(Pol_S\) Pol % sugar -
\(Pol_{S,c}\) Pol in sugar % cane -
\(L_t\) Total losses % cane -
\(L_d\) Determined losses % cane -
\(L_u\) Unknown losses % cane -

Method and standards

Pol balance.

Where it is used

  • Daily and season pol balance.
  • Loss reduction programmes.

Common mistakes

  • No stock correction over a week.

Assumptions and limits

  • Same basis for all terms.
  • Negative total losses (more pol in sugar than in cane) and negative unknown losses are flagged.

References

  • Sugar factory chemical control (daily manufacturing report) definitions
  • as compiled in SugarProcessTech
  • Formulas for calculating sugar industry DMR

Questions and answers

What are unknown losses?

Pol not found in sugar, bagasse, cake or molasses: inversion, entrainment, spills and errors.

Typical unknown losses?

A small fraction of a per cent of cane; a rising trend points to inversion or entrainment.

Stock in process?

Correct for stock changes before closing a short period.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.