Worked example
Example: 60 mm x 1 m, 5 kg, oil 850, 0.4 m covered. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Displacer diameter | 60.000 mm |
| Displacer length (measuring range) | 1.0000 m |
| Displacer mass | 5.0000 kg |
| Liquid density | 850.00 kg/m³ |
| Vapour density above the liquid | 1.2000 kg/m³ |
| Level on the displacer (from its bottom) | 0.40000 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Buoyancy at the level | 9.4474 N |
| Apparent weight at the level | 39.586 N |
| Force change over the full range | 23.535 N |
| Level as a share of the range | 40.000 % |
Open this example in the calculator and change any input.
Formula
\(F_b = g A [\rho h + \rho_v (L - h)], \quad W_a = m g - F_b, \quad \Delta F = g A L (\rho - \rho_v)\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(d\) | Displacer diameter | m |
| \(L\) | Displacer length (measuring range) | m |
| \(m\) | Displacer mass | kg |
| \(\rho\) | Liquid density | kg/m³ |
| \(\rho_v\) | Vapour density above the liquid | kg/m³ |
| \(h\) | Level on the displacer (from its bottom) | m |
| \(F_b\) | Buoyancy at the level | N |
| \(W_a\) | Apparent weight at the level | N |
| \(\Delta F\) | Force change over the full range | N |
| \(h/L\) | Level as a share of the range | - |
Method and standards
Archimedes' principle.
Where it is used
- Level control in drums, separators and condensers.
- Calibration with water.
Common mistakes
- Ignoring vapour density at high pressure.
- Wrong liquid density.
Assumptions and limits
- Vertical cylindrical displacer; liquid denser than the vapour.
- A negative apparent weight (the displacer would float) is flagged.
References
- Archimedes' principle
Questions and answers
What force change does a 60 mm × 1 m displacer give in 850 kg/m³ oil?
23.5 N over the range.
Why does density matter?
Buoyancy is density × displaced volume, so a lighter liquid reads low.
Can displacers measure interface?
Yes, fully submerged, by the density difference of the two liquids.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.