FireCADCalc

Stopping Sight Distance (Reaction and Braking)

Stopping sight distance of a vehicle from speed, perception–reaction time and braking friction (deceleration a = f g), including the effect of a grade.

Inputs

Examples: 80 km/h level60 km/h, 5 % downgrade30 km/h uphill 3 %

From your road standard for the speed.

Results

Reaction distance v t_r55.556m
Braking distance v²/(2g(f + G))71.938m
Stopping sight distance127.49m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 80 km/h level. The inputs, in the units selected above:

InputValue
Speed80.000 km/h
Perception–reaction time2.5000 s
Longitudinal friction factor0.35000 -
Grade (positive uphill)0 %

Applying the formula below gives:

ResultValue
Reaction distance v t_r55.556 m
Braking distance v²/(2g(f + G))71.938 m
Stopping sight distance127.49 m

Open this example in the calculator and change any input.

Formula

\(SSD = v t_r + \frac{v^2}{2 g (f + G)}\)

Variables

Symbol Meaning SI unit
\(v\) Speed m/s
\(t_r\) Perception–reaction time s
\(f\) Longitudinal friction factor -
\(G\) Grade (positive uphill) -
\(d_r\) Reaction distance v t_r m
\(d_b\) Braking distance v²/(2g(f + G)) m
\(SSD\) Stopping sight distance m

Method and standards

Uniform deceleration after the reaction time.

Where it is used

  • Road and junction layout.
  • Site traffic plans.

Common mistakes

  • km/h in the formula.
  • Ignoring grade.

Assumptions and limits

  • Constant friction. To work from a deceleration a instead, enter f = a/g: the AASHTO 2011 value a = 3.4 m/s² is f = 0.347.

References

  • SSD = v t + v²/(2g(f ± G)) (AASHTO Green Book and IRC basic relation)

Questions and answers

80 km/h, 2.5 s, f 0.35, level?

Reaction 55.6 m, braking 71.9 m, total 127 m.

Downhill?

Use a negative grade: braking distance grows.

Where is it used?

Setting sight lines at bends, crests and junctions, including plant roads.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.