Worked example
Example: 80 km/h on 300 m. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Design speed | 80.000 km/h |
| Curve radius | 300.00 m |
| Maximum superelevation allowed | 7.0000 % |
| Side friction factor allowed | 0.15000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Total needed v²/(gR) | 0.16785 |
| Superelevation needed if friction takes its full share | 1.7855 % |
| Minimum radius for e_max and f | 228.89 m |
| Safe speed on this radius | 91.587 km/h |
Open this example in the calculator and change any input.
Formula
\(e + f = \frac{v^2}{g R}, \quad R_{min} = \frac{v^2}{g(e_{max} + f)}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(v\) | Design speed | m/s |
| \(R\) | Curve radius | m |
| \(e_{max}\) | Maximum superelevation allowed | - |
| \(f\) | Side friction factor allowed | - |
| \(e + f\) | Total needed v²/(gR) | - |
| \(e_n\) | Superelevation needed if friction takes its full share | - |
| \(R_{min}\) | Minimum radius for e_max and f | m |
| \(v_{safe}\) | Safe speed on this radius | m/s |
Method and standards
Equilibrium on a banked curve.
Where it is used
- Road and plant road design.
- Speed limits on bends.
Common mistakes
- km/h in the formula.
- Ignoring standard limits.
Assumptions and limits
- Point mass, small angles.
- When e_n exceeds e_max (radius below R_min) the page warns: the curve cannot carry the design speed within the allowed superelevation and friction.
References
- Point-mass equilibrium on a banked curve
- e + f = v²/(gR) (AASHTO and IRC basic relation)
Questions and answers
80 km/h on a 300 m radius?
e + f = 0.168; minimum radius 229 m with e 7 % and f 0.15.
Why limit superelevation?
Slow vehicles would slide inwards on a steep bank.
Plant roads?
Low speeds need little superelevation but tight radii still need checks.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.