Worked example
Example: 7 m at 2.5 %. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Carriageway width | 7.0000 m |
| Cross fall | 2.5000 % |
| Distance from the crown (for the drop) | 2.0000 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Crown height above the edge c W/2 | 87.500 mm |
| Camber as 1 in n | 40.000 |
| Drop at the distance x | 50.000 mm |
Open this example in the calculator and change any input.
Formula
\(h = c\,\frac{W}{2}, \quad n = \frac{1}{c}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(W\) | Carriageway width | m |
| \(c\) | Cross fall | - |
| \(x\) | Distance from the crown (for the drop) | m |
| \(h\) | Crown height above the edge c W/2 | m |
| \(n\) | Camber as 1 in n | - |
| \(\Delta h_x\) | Drop at the distance x | m |
Method and standards
Straight-line camber.
Where it is used
- Road and yard pavements.
- Plant roads and hardstands.
Common mistakes
- Full width instead of half.
- Percent vs 1 in n confusion.
Assumptions and limits
- Two-plane camber.
References
- Straight (two-plane) camber geometry
Questions and answers
A 7 m road at 2.5 % cross fall?
Crown 87.5 mm above the edges: 1 in 40.
Why camber?
To drain water off the surface quickly.
Which cross fall?
Your road standard's figure for the surface and rainfall.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.