FireCADCalc

Road Camber (Cross Fall): Crown Height and Slope

Height of the crown above the edges of a cambered road from the carriageway width and cross fall, with the camber as 1 in n and the drop at a distance from crown.

Inputs

Examples: 7 m at 2.5 %3.75 m plant road at 1 in 48Gravel road 6 m at 4 %

From your road standard for the surface type and rainfall.

Results

Crown height above the edge c W/2120.00mm
Camber as 1 in n25.000
Drop at the distance x120.00mm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 7 m at 2.5 %. The inputs, in the units selected above:

InputValue
Carriageway width7.0000 m
Cross fall2.5000 %
Distance from the crown (for the drop)2.0000 m

Applying the formula below gives:

ResultValue
Crown height above the edge c W/287.500 mm
Camber as 1 in n40.000
Drop at the distance x50.000 mm

Open this example in the calculator and change any input.

Formula

\(h = c\,\frac{W}{2}, \quad n = \frac{1}{c}\)

Variables

Symbol Meaning SI unit
\(W\) Carriageway width m
\(c\) Cross fall -
\(x\) Distance from the crown (for the drop) m
\(h\) Crown height above the edge c W/2 m
\(n\) Camber as 1 in n -
\(\Delta h_x\) Drop at the distance x m

Method and standards

Straight-line camber.

Where it is used

  • Road and yard pavements.
  • Plant roads and hardstands.

Common mistakes

  • Full width instead of half.
  • Percent vs 1 in n confusion.

Assumptions and limits

  • Two-plane camber.

References

  • Straight (two-plane) camber geometry

Questions and answers

A 7 m road at 2.5 % cross fall?

Crown 87.5 mm above the edges: 1 in 40.

Why camber?

To drain water off the surface quickly.

Which cross fall?

Your road standard's figure for the surface and rainfall.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.