Worked example
Example: R 300 m, 40 degrees. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Radius | 300.00 m |
| Deflection angle | 40.000 ° |
| Chainage of the intersection point | 1,000.0 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Tangent length R tan(Δ/2) | 109.19 m |
| Curve length R Δ | 209.44 m |
| Long chord 2R sin(Δ/2) | 205.21 m |
| External distance R(sec(Δ/2) − 1) | 19.253 m |
| Middle ordinate R(1 − cos(Δ/2)) | 18.092 m |
| Chainage of the start of the curve | 890.81 m |
| Chainage of the end of the curve | 1,100.2 m |
Open this example in the calculator and change any input.
Formula
\(T = R\tan\frac{\Delta}{2}, \quad L = R\Delta, \quad C = 2R\sin\frac{\Delta}{2}, \quad E = R\left(\sec\frac{\Delta}{2} - 1\right), \quad M = R\left(1 - \cos\frac{\Delta}{2}\right)\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(R\) | Radius | m |
| \(\Delta\) | Deflection angle | rad |
| \(C_{PI}\) | Chainage of the intersection point | m |
| \(T\) | Tangent length R tan(Δ/2) | m |
| \(L\) | Curve length R Δ | m |
| \(C\) | Long chord 2R sin(Δ/2) | m |
| \(E\) | External distance R(sec(Δ/2) − 1) | m |
| \(M\) | Middle ordinate R(1 − cos(Δ/2)) | m |
| \(C_{PC}\) | Chainage of the start of the curve | m |
| \(C_{PT}\) | Chainage of the end of the curve | m |
Method and standards
Circle geometry.
Where it is used
- Road, rail and pipeline alignment.
- Surveying examinations.
Common mistakes
- Δ in degrees in R Δ.
- Chainage of PT as PI + T.
Assumptions and limits
- Simple circular curve.
References
- Simple circular curve geometry (surveying texts)
Questions and answers
R 300 m, Δ 40°?
Tangent 109.19 m, curve 209.44 m, external 19.25 m.
Why chainages?
To set the curve out from the start point along the route.
Railways and pipes?
The same geometry applies.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.