Worked example
Example: BMA type. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Crushing rate | 250.00 t/h |
| Fibre % cane | 14.500 % |
| Dissolved solids in bagasse per unit fibre | 4.0000 % |
| Moisture of megasse leaving the diffuser | 85.000 % |
| Moisture after the dewatering roller or press | 76.000 % |
| Final bagasse moisture (wet basis) | 50.000 % |
| Dewatering power per tonne cane per hour | 4.5000 kWh/t |
Applying the formula below gives:
| Result | Value |
|---|---|
| Megasse leaving the diffuser | 251.33 t/h |
| Bagasse after the dewatering roller | 157.08 t/h |
| Final bagasse | 75.400 t/h |
| Press water returned | 175.93 t/h |
| Dewatering power | 1,125.0 kW |
Open this example in the calculator and change any input.
Formula
\(M_i = \frac{A f(1 + r)}{1 - w_i}, \quad W_p = M_0 - M_2, \quad P = e A\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(A\) | Crushing rate | kg/s |
| \(f\) | Fibre % cane | - |
| \(r\) | Dissolved solids in bagasse per unit fibre | - |
| \(w_0\) | Moisture of megasse leaving the diffuser | - |
| \(w_1\) | Moisture after the dewatering roller or press | - |
| \(w_2\) | Final bagasse moisture (wet basis) | - |
| \(e\) | Dewatering power per tonne cane per hour | J/kg |
| \(M_0\) | Megasse leaving the diffuser | kg/s |
| \(M_1\) | Bagasse after the dewatering roller | kg/s |
| \(M_2\) | Final bagasse | kg/s |
| \(W_p\) | Press water returned | kg/s |
| \(P\) | Dewatering power | W |
Method and standards
Dry-solids balance.
Where it is used
- Sizing dewatering mills and press-water pumps.
- Boiler fuel moisture estimates.
Common mistakes
- Leaving out dissolved solids.
- Using moisture on dry basis.
Assumptions and limits
- Constant solids through the presses: one dissolved-solids ratio r for all stages. The press water removes some sugar, so the final bagasse flow is slightly overstated.
- Moistures are on the wet basis (water per kg of wet bagasse); convert a dry-basis figure before using it in other calculators.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 23
- megasse and dewatering (BMA and Silver data)
- pp. 383–392
Questions and answers
Why is megasse so wet?
It leaves the diffuser saturated with about 85 % water; pressing brings it to about 50 % for the boilers.
Where does the press water go?
Back to the diffuser, so its sugar is not lost.
Feed openings of dewatering mills?
Hugot: feed to delivery ratios of 3:1 to 4:1, wider than normal mills.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.