FireCADCalc

Fan and Impeller Tip Speed

Tip (peripheral) speed of a fan or pump impeller from diameter and speed, with the speed for a tip-speed limit and the blade passing frequency.

Thermal power plantProcess steam and utilitiesSugar mill and cogeneration

Inputs

Examples: 1.2 m fan at 990 rpm, 12 bladesPump impeller 350 mm at 2 950 rpm, 6 vanesCooling tower fan 6 m at 150 rpm, 8 blades

From the fan maker or your specification.

Results

Tip speed π D N47.124m/s
Highest speed for the tip limit190.99rpm
Blade passing frequency20.000Hz

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 1.2 m fan at 990 rpm, 12 blades. The inputs, in the units selected above:

InputValue
Impeller diameter1,200.0 mm
Speed990.00 rpm
Number of blades12.000 -
Tip speed limit (for the highest speed)90.000 m/s

Applying the formula below gives:

ResultValue
Tip speed π D N62.204 m/s
Highest speed for the tip limit1,432.4 rpm
Blade passing frequency198.00 Hz

Open this example in the calculator and change any input.

Formula

\(u = \pi D N, \quad f_b = z N\)

Variables

Symbol Meaning SI unit
\(D\) Impeller diameter m
\(N\) Speed 1/s
\(z\) Number of blades -
\(u_{max}\) Tip speed limit (for the highest speed) m/s
\(u\) Tip speed π D N m/s
\(N_{max}\) Highest speed for the tip limit 1/s
\(f_b\) Blade passing frequency 1/s

Method and standards

Kinematics.

Where it is used

  • Fan speed-up checks.
  • Noise and vibration analysis.

Common mistakes

  • rpm vs rev/s.
  • Radius for diameter.

Assumptions and limits

  • Rigid rotor.
  • A tip speed above the entered limit is flagged.

References

  • u = π D N

Questions and answers

1.2 m fan at 990 rpm?

Tip speed 62.2 m/s; blade passing 198 Hz with 12 blades.

Why limit tip speed?

Stress in the impeller and noise rise with it.

Is it the same for pumps?

Yes; it also sets the head the impeller can make.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.