Worked example
Example: 1.2 m fan at 990 rpm, 12 blades. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Impeller diameter | 1,200.0 mm |
| Speed | 990.00 rpm |
| Number of blades | 12.000 - |
| Tip speed limit (for the highest speed) | 90.000 m/s |
Applying the formula below gives:
| Result | Value |
|---|---|
| Tip speed π D N | 62.204 m/s |
| Highest speed for the tip limit | 1,432.4 rpm |
| Blade passing frequency | 198.00 Hz |
Open this example in the calculator and change any input.
Formula
\(u = \pi D N, \quad f_b = z N\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(D\) | Impeller diameter | m |
| \(N\) | Speed | 1/s |
| \(z\) | Number of blades | - |
| \(u_{max}\) | Tip speed limit (for the highest speed) | m/s |
| \(u\) | Tip speed π D N | m/s |
| \(N_{max}\) | Highest speed for the tip limit | 1/s |
| \(f_b\) | Blade passing frequency | 1/s |
Method and standards
Kinematics.
Where it is used
- Fan speed-up checks.
- Noise and vibration analysis.
Common mistakes
- rpm vs rev/s.
- Radius for diameter.
Assumptions and limits
- Rigid rotor.
- A tip speed above the entered limit is flagged.
References
- u = π D N
Questions and answers
1.2 m fan at 990 rpm?
Tip speed 62.2 m/s; blade passing 198 Hz with 12 blades.
Why limit tip speed?
Stress in the impeller and noise rise with it.
Is it the same for pumps?
Yes; it also sets the head the impeller can make.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.