FireCADCalc

Setting Out a Curve: Offsets from the Long Chord and Tangent

Offsets for setting out a circular curve from the long chord (mid-ordinate and offset at any distance) and perpendicular offsets from the tangent.

Inputs

Examples: R 300 m, 200 m chordSharp R 40 m, 60 m chordAt the mid-point

Results

Mid-ordinate R − √(R² − (L/2)²)13.542m
Offset from the long chord at x8.1835m
Perpendicular offset from the tangent R − √(R² − x_t²)2.9190m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: R 300 m, 200 m chord. The inputs, in the units selected above:

InputValue
Radius300.00 m
Long chord200.00 m
Distance from the chord mid-point50.000 m
Distance along the tangent from the start50.000 m

Applying the formula below gives:

ResultValue
Mid-ordinate R − √(R² − (L/2)²)17.157 m
Offset from the long chord at x12.961 m
Perpendicular offset from the tangent R − √(R² − x_t²)4.1960 m

Open this example in the calculator and change any input.

Formula

\(O_0 = R - \sqrt{R^2 - (L/2)^2}, \quad O_x = \sqrt{R^2 - x^2} - (R - O_0), \quad O_t = R - \sqrt{R^2 - x_t^2}\)

Variables

Symbol Meaning SI unit
\(R\) Radius m
\(L\) Long chord m
\(x\) Distance from the chord mid-point m
\(x_t\) Distance along the tangent from the start m
\(O_0\) Mid-ordinate R − √(R² − (L/2)²) m
\(O_x\) Offset from the long chord at x m
\(O_t\) Perpendicular offset from the tangent R − √(R² − x_t²) m

Method and standards

Circle geometry.

Where it is used

  • Setting out roads, drains and pipe bends on site.
  • Surveying examinations.

Common mistakes

  • Measuring x from the chord end in the mid-point formula.
  • Using approximations on sharp curves.

Assumptions and limits

  • Exact circle.

References

  • Exact circle offsets from the long chord and tangent (surveying texts)

Questions and answers

R 300 m, 200 m chord?

Mid-ordinate 17.157 m; at 50 m from the middle 12.961 m.

Approximate formula?

O ≈ x(L − x)/2R from one end, close for flat curves.

Long curves?

Use deflection angles with a theodolite instead.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.