FireCADCalc

Van der Waals Equation: Pressure and Compressibility

Pressure of a real gas from temperature and molar volume by the van der Waals equation with a and b from the critical constants, against the ideal gas.

Refinery and petrochemicalChemical and fertiliser

Inputs

Examples: CO2 at 300 K, 0.5 L/molNitrogen at 200 K, 1 L/mol

Results

Van der Waals is qualitative; use Peng–Robinson for design.

a = 27R²T_c²/(64p_c) (Pa·m⁶/mol²)0.13676
b = RT_c/(8p_c)0.038621L/mol
Pressure15.929bar
Ideal gas pressure16.629bar
Compressibility pv/RT0.95793

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: CO2 at 300 K, 0.5 L/mol. The inputs, in the units selected above:

InputValue
Temperature26.850 °C
Molar volume0.50000 L/mol
Critical temperature30.980 °C
Critical pressure73.770 bar

Applying the formula below gives:

ResultValue
a = 27R²T_c²/(64p_c) (Pa·m⁶/mol²)0.36567
b = RT_c/(8p_c)0.042847 L/mol
Pressure39.936 bar
Ideal gas pressure49.887 bar
Compressibility pv/RT0.80053

Open this example in the calculator and change any input.

Formula

\(p = \frac{RT}{v - b} - \frac{a}{v^2}, \quad a = \frac{27R^2T_c^2}{64p_c}, \quad b = \frac{RT_c}{8p_c}\)

Variables

Symbol Meaning SI unit
\(T\) Temperature K
\(v\) Molar volume m³/mol
\(T_c\) Critical temperature K
\(p_c\) Critical pressure Pa
\(a\) a = 27R²T_c²/(64p_c) (Pa·m⁶/mol²) -
\(b\) b = RT_c/(8p_c) m³/mol
\(p\) Pressure Pa
\(p_{ideal}\) Ideal gas pressure Pa
\(Z\) Compressibility pv/RT -

Method and standards

Van der Waals.

Where it is used

  • Teaching and examinations.
  • Quick real-gas checks.

Common mistakes

  • Specific instead of molar volume.
  • Using it for design.

Assumptions and limits

  • Pure gas.

References

  • Van der Waals (1873) equation with a and b from the critical point

Questions and answers

CO₂ at 300 K and 0.5 L/mol?

About 40 bar by van der Waals against 50 bar ideal.

Why are a and b from the critical point?

Matching the critical inflection fixes both constants.

How accurate?

Rough; it shows the trends but not design accuracy.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.