FireCADCalc

Vehicle Speed from Engine Speed, Gear Ratio and Tyre

Wheel speed and road speed from engine speed, gear ratio, final drive ratio and tyre rolling radius, and the engine speed at a chosen road speed.

Thermal power plantProcess steam and utilitiesSugar mill and cogeneration

Inputs

Examples: Top gear, 4.1 final drive, 3,000 rpmTruck 3rd gear 2.5, 5.3 final, 1,800 rpm

Results

No slip; rolling radius is a little less than the unloaded tyre radius (about 97 %). Torque converter slip in automatics lowers the road speed.

Wheel speed135.85rpm
Road speed25.607km/h
Overall ratio13.250
Engine speed at v_t2,811.7rpm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Top gear, 4.1 final drive, 3,000 rpm. The inputs, in the units selected above:

InputValue
Engine speed3,000.0 rpm
Gear ratio1.0000 -
Final drive ratio4.1000 -
Tyre rolling radius310.00 mm
Road speed of interest100.00 km/h

Applying the formula below gives:

ResultValue
Wheel speed731.71 rpm
Road speed85.513 km/h
Overall ratio4.1000
Engine speed at v_t3,508.3 rpm

Open this example in the calculator and change any input.

Formula

\(n_w = \frac{n_e}{i_gi_0}, \quad v = 2\pi rn_w\)

Variables

Symbol Meaning SI unit
\(n_e\) Engine speed 1/s
\(i_g\) Gear ratio -
\(i_0\) Final drive ratio -
\(r\) Tyre rolling radius m
\(v_t\) Road speed of interest m/s
\(n_w\) Wheel speed 1/s
\(v\) Road speed m/s
\(i_t\) Overall ratio -
\(n_{e,t}\) Engine speed at v_t 1/s

Method and standards

Driveline kinematics.

Where it is used

  • Gear selection for haulage tractors and trucks.
  • Speedometer checks.

Common mistakes

  • Using unloaded tyre radius.
  • Forgetting the final drive.

Assumptions and limits

  • No slip.

References

  • Kinematics of the driveline (Gillespie, Fundamentals of Vehicle Dynamics (SAE, 1992), ch. 2)

Questions and answers

Why does a lower gear give lower speed?

A higher numerical ratio turns the wheels fewer times per engine revolution.

How do I find the rolling radius?

Measure the distance travelled in ten wheel turns and divide by 20π, or use the tyre maker's revolutions per kilometre.

What do the defaults represent?

A car in top gear (1:1) with a 4.1 final drive and 0.31 m tyres at 3,000 rpm.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.