Worked example
Example: 1.5 t front-drive car, first gear, dry. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Engine torque | 250.00 N·m |
| Gear ratio | 3.5000 - |
| Final drive ratio | 4.1000 - |
| Drivetrain efficiency | 88.000 % |
| Tyre rolling radius | 310.00 mm |
| Vehicle mass | 1,500.0 kg |
| Rolling resistance coefficient | 0.012000 - |
| Tyre–road adhesion coefficient | 0.80000 - |
| Share of weight on the driven axle | 60.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Tractive effort from the engine | 10,184 N |
| Adhesion limit of the driven axle | 7,060.8 N |
| Usable tractive effort | 7,060.8 N |
| Maximum gradeability (rise/run) | 53.161 % |
Open this example in the calculator and change any input.
Formula
\(F_t = \frac{T_ei_gi_0\eta_d}{r}, \quad F_\mu = \mu\phi mg, \quad F = mg(C_{rr}\cos\theta + \sin\theta)\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(T_e\) | Engine torque | N·m |
| \(i_g\) | Gear ratio | - |
| \(i_0\) | Final drive ratio | - |
| \(\eta_d\) | Drivetrain efficiency | - |
| \(r\) | Tyre rolling radius | m |
| \(m\) | Vehicle mass | kg |
| \(C_{rr}\) | Rolling resistance coefficient | - |
| \(\mu\) | Tyre–road adhesion coefficient | - |
| \(\phi\) | Share of weight on the driven axle | - |
| \(F_t\) | Tractive effort from the engine | N |
| \(F_{\mu}\) | Adhesion limit of the driven axle | N |
| \(F\) | Usable tractive effort | N |
| \(G_{max}\) | Maximum gradeability (rise/run) | - |
Method and standards
Force balance.
Where it is used
- Haulage on ramps and yard gradients.
- Gear ratio selection.
Common mistakes
- Ignoring adhesion on wet or loose surfaces.
- Using peak torque at the wrong speed.
Assumptions and limits
The adhesion limit uses the static share of weight on the driven axle. On a climb weight moves to the rear axle, so the limit is overstated for front-wheel drive and understated for rear-wheel drive.
When the usable effort exceeds the vehicle weight the gradeability is unbounded and is not shown.
Low speed; steady climb.
References
- Tractive effort and gradeability (Gillespie, Fundamentals of Vehicle Dynamics (SAE, 1992), ch. 2)
Questions and answers
Why can't more torque always climb steeper?
The driven tyres slip once tractive effort exceeds μ times the load on them.
What gradient can a loaded truck climb?
Typically 30–40 % in first gear on dry roads, limited by adhesion and engine torque.
What do the defaults represent?
A 1.5 t front-drive car in first gear on a dry road.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.