Worked example
Example: Top gear, 4.1 final drive, 3,000 rpm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Engine speed | 3,000.0 rpm |
| Gear ratio | 1.0000 - |
| Final drive ratio | 4.1000 - |
| Tyre rolling radius | 310.00 mm |
| Road speed of interest | 100.00 km/h |
Applying the formula below gives:
| Result | Value |
|---|---|
| Wheel speed | 731.71 rpm |
| Road speed | 85.513 km/h |
| Overall ratio | 4.1000 |
| Engine speed at v_t | 3,508.3 rpm |
Open this example in the calculator and change any input.
Formula
\(n_w = \frac{n_e}{i_gi_0}, \quad v = 2\pi rn_w\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(n_e\) | Engine speed | 1/s |
| \(i_g\) | Gear ratio | - |
| \(i_0\) | Final drive ratio | - |
| \(r\) | Tyre rolling radius | m |
| \(v_t\) | Road speed of interest | m/s |
| \(n_w\) | Wheel speed | 1/s |
| \(v\) | Road speed | m/s |
| \(i_t\) | Overall ratio | - |
| \(n_{e,t}\) | Engine speed at v_t | 1/s |
Method and standards
Driveline kinematics.
Where it is used
- Gear selection for haulage tractors and trucks.
- Speedometer checks.
Common mistakes
- Using unloaded tyre radius.
- Forgetting the final drive.
Assumptions and limits
- No slip.
References
- Kinematics of the driveline (Gillespie, Fundamentals of Vehicle Dynamics (SAE, 1992), ch. 2)
Questions and answers
Why does a lower gear give lower speed?
A higher numerical ratio turns the wheels fewer times per engine revolution.
How do I find the rolling radius?
Measure the distance travelled in ten wheel turns and divide by 20π, or use the tyre maker's revolutions per kilometre.
What do the defaults represent?
A car in top gear (1:1) with a 4.1 final drive and 0.31 m tyres at 3,000 rpm.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.