FireCADCalc

Solar Inverter DC/AC Ratio (Inverter Loading)

DC to AC ratio of a solar PV plant from the array kWp and the inverter rating and number, with the DC power per inverter and the oversizing.

Inputs

Examples: 600 kWp on five 100 kW inverters8.2 kWp on one 6 kW inverter50 MWp on 16 inverters of 2.5 MW

Results

A ratio above 1 clips the output on the clearest days but raises the energy from each inverter; the limit is the inverter maker's permitted DC power and current.

DC/AC ratio1.2000
DC power per inverter120.00kW
Oversizing of the array over the inverters20.000%
Total inverter rating500.00kW

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 600 kWp on five 100 kW inverters. The inputs, in the units selected above:

InputValue
Array rating600.00 kW
Rating of one inverter100.00 kW
Number of inverters5.0000 -

Applying the formula below gives:

ResultValue
DC/AC ratio1.2000
DC power per inverter120.00 kW
Oversizing of the array over the inverters20.000 %
Total inverter rating500.00 kW

Open this example in the calculator and change any input.

Formula

\(R = \frac{P_{dc}}{n\, P_{ac}}\)

Variables

Symbol Meaning SI unit
\(P_{dc}\) Array rating W
\(P_{ac}\) Rating of one inverter W
\(n\) Number of inverters -
\(R\) DC/AC ratio -
\(P_{dc,1}\) DC power per inverter W
\(o\) Oversizing of the array over the inverters -
\(P_{ac,t}\) Total inverter rating W

Method and standards

Ratio of ratings.

Where it is used

  • Plant design and inverter selection.

Common mistakes

  • Exceeding the maker's DC limits.

Assumptions and limits

  • Ratings only; no energy simulation.

References

  • Definition: array STC power / inverter AC rating

Questions and answers

What is the ratio of 600 kWp on five 100 kW inverters?

1.2: the array is 20 % larger than the inverters.

Is that allowed?

Usually; check the inverter's maximum DC power, voltage and current.

Why oversize?

Modules rarely reach their rated power in the field.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.